Forum Replies Created
-
Posts
-
Re: Hotpoint door seal part no.?
168908 is the door seal you require not used one for a long time now cheers JJ
Re: Fitting thermistor to Indesit WIDL126
Think the one you have is the the pre idc connector dryer thermistor, the wash thermistor is a plastic can this has a metal can.
Re: tdl10
I take it the drier doesnt have bearing pads in the front support duct, if this is the case only way to cure is to fit drum and duct kit 1702495.
Re: HOTPOINT WMA36s – door lock light flashing – UPDATE
If your machine is under 5 years old it will be £89.98 or if it is between 5 and 10 years old it will cost £99.98, parts all included only through Hotpoint.
Re: Hotpoint WF540P cold fill only
Now if you stayed just round the corner???? it would be very reasonable
Re: Hotpoint WMA11 – I just cant pin this down??
As suedhead says blown tracks on the board are usualy caused by harness rubbing on balnce weight or motor brushes shorting out taking out the module, it is most common after somebody has change the tub and never tied the wiring back out off the way of the balance weight.
Re: indersit wi 101
Check for a dry joint on the module at the heater relay, this can cause this fault also.
Re: tecnik TKC 1065
The only n/os i could locte were E-NR HB2T15T1
HM44141 and A-28-893550 tried various sites but to no avail cheers JJRe: hotpoint aqualtis
Probly door lock, no brushes on these, to be honest not had a lot of problems with them.
Re: Qualtex on line ordering?
Works okay for me, not to impressed with the pricing though, most things are dearer than my other accounts.
Re: Hotpoint condensor dryer problem
Does the capacitor have a white cap on it, if so replace it they fail for fun.
