Forum Replies Created
-
Posts
-
Re: Hotpoint WM73 bearing replacment
I have a hotpoint wf860p for a year and a bit been great, married 22 years 3 machines and all still running sweet as a nut, old dear down the road got my old 95492a when i picked up a wm22w that someone was putting out due to new kitchen hads that for ages my pal who seperated from his missus gave him it and expect this to be as good
Re: Hotpoint D/W strange leak
If the spray arm has a split in it will cause it to leak i have always fitted a new bottom spray arm and a door seal never had a call back yet.
Re: 1701583
Not realy i have a condensor t/dryer stats have never failed on mine 5 years old, but then again i dont open door before tumble cool , i clean filter, condensor , choose the correct programe for which is being dried, i suppose somebody using a washing machine as a bank is a design fault also.
Re: 1701583
Replace with a 2.3kw heater and you will find the stats raley fail hotpoint tech/bull advise’s if failing regularily.
Re: hotpoint WMS38 bearing change required?
Every Hotpoint engineer has a vanstock of 3 rear halfs and 3 drum spiders but if they have not been allocated 2 slots i’m afraid they wont do on the first call.
Re: Hotpoint WF540
Could be one off the suspension pegs are out seen this a few times on new machines this causes the exact symptom you are getting it is actualy a good machine that model.
Re: Hotpoint WMA46 problems
If the control module is blown check wiring down by the bottom balance weight has not been rubbing on it, but i would guess your machine is fitted with a Bosch motor. You can tell if it is as the brush holders have a white cover on them, if you have better phone Hotpoint as the Bosch motor is cr@p and has a habit of blowing module and door interlock when brushes go. They will replace motor with FHP motor which is quieter also.
Re: Yep, another Ariston AWD12 SUK – 13 flashes
If its not a broken wire at the thermistor, it normaly is the module for this fault i’m afraid.
Re: Hotpoint WD865 WasherDryer leaking from base on dry onl
I’m a Hotpoint engineer most eng’s let it go and dont chge, if its rubbish in the machine usualy a warning is enough to get them to check the wash after the second taking crap out , i’ll chge on the 3’rd visit, in my book charging for faulty instalation etc will only get customers back if another problem happens and is a machine fault.
Re: Hotpoint American style fridge/freezer Model 8923
You will have to remove icemaker then remove the back panel which gives access to evaporator area for the heaters the defrost timer is located in the control panel in the fridge.
Re: Creda Excel Dryer Model T602CW – leaking
Sounds like a blockage in the condensor by not cleaning regular take it out and reach to back and make sure the hole down to float chambers is not blocked with fluff, if this gets blocked it will still make condensate but not fill bottle and leak all over floor.
Re: Really smart tumble dryers?
Some sensor dryers use thermistors in the exhaust the air intake and at the heater they determine when the the load is dry as the exhaust gets hotter they are oviously dryer, others work on the conductifity method as a load drys the resistance gets higher hence the contorls know how dry, only drawback with this if you want to dry a small load the most off the airflow misses the load causing the sensors to dry out resulting in load not drying.
