Forum Replies Created
-
Posts
-
Re: Candy CBCA260UK
It s oakay chaps i’ve found it seems there is a mod kit, looks like they have been overheating and going o/cct cheers JJ
Re: hotpoint ctd 40 t/d
How old is it, ones made from approx june/07 if the stats go open circuit the whole machine goes dead no lights nothing, other than that i’d be thinking module i’m afraid.
Re: Indesit IDL 530 diswasher
No heat is normaly a module fault, they usualy go through to the end though.
Re: Ariston A1636
I usualy pop a press sw in 1st for F08 faults, as i’ve been caught out a few times plumping for the module only to find its the press switch.
Re: Diplomat ADP8352
Thanks for your help, there was signs of water in base but it was all dried out by the time i saw it, looks like a board then cheers jj
Re: Hotpoint TDC62 dryer dries intermittently
Could be but i would prob’ly go for the dryness module, myself.
Re: what do you think of this machine !
I,ve done 1 drum for bearing failure, a couple of modules most of the rest just rubbish in the pump, wasnt sure about them at 1st, i,ve now recomended a good few and so far everbody is happy with them.
Re: Beko DE2431FS
I ordered this board only to find it is indeed the wrong board, the one i,m after has 1899460004 stamped on it i have been unable to source one, i,ve tried Beko, connect etc still no joy anybody any ideas where i might get one cheers jj.
Re: Hotpoint FDW70T. Detergent rinse aid draw
The differance is usualy one has a reed sw to detect rinse aid, i usualy fit that one to most of them, jj
