Forum Replies Created
-
Posts
-
Re: Zanussi ZJ1218 E30
Geof the black press sw was not connected to the crossmember but was hanging loose i clipped in a space next to the other one, is it suppused to clip to the underside of the crossmember. jj
Re: Creda T632CW
A short circuit from the sensor band to the drum will cause this fault, is the insulator band insulating the sensor band from the drum also check the sensor disc is insulated from the drum, if so looks like a module fault. JJ
Re: Hotpoint WD860 no dryer
If everything else checks out i’d guess a duff module Jim, F14 no heat to dryer, flickering display will need a new console module, there was a resistor changed on these to cure .
Re: Hotpoint tdc62p wont stay on dry long enough
Have you checked there is continuity from the sensor band through the sensor brush etc if there is an open circuit there, it will mimmick a dry load even when load is wet and end dry, other than that i’d go for dryness module. jj.
Re: Teka WMFI2
Thanks Chris i’ve checked EMW etc, found it on Qualtex a little bit cheaper i think i’ll go with that. JJ
Re: Hotpoint Oven SD97I
Think its indesit techonlogy module and eeprom required ,how life was so simple stats, regulators etc in years gone bye who the fcuk needs pizza mode and all the other crap?
Re: hotpoint BFi670 configure
I know it is a dishwasher and it should have a small edged connector sometimse with a resistor attached, it is there to determine if it is free standing or built inn if it is not there you wont get it out off the test programe.
Re: hotpoint BFi670 configure
Did you swap over the edge conector on the side of the timer, i’ve seen a few forget to do this and you will get a the test programe but will do nothing else, also when you fit the board to get it out of the test programe when the fill starts you cancel programe and it should be set for normal operation , hope this helps JJ
