Forum Replies Created
-
Posts
-
Re: Lamona HJA8630 dishwasher – all programme lights on
It’s the module. However I’ve since discovered that you can cure this by replacing the large grew capacitor. So if you fit s new mod, keep old one repair it.
Re: Hoover Condenser Dryer Skipping to cool down cycle
just replaced relay on a hoover board today. i do one every now and again. sometimes no heat and sometimes constant heat. (bit like beko dishwasher boards.)
Re: Bosch oven no display
ive had a similar thing with a bosch display flashing continuously.
turned out to be capacitor on the board. cant remember its value. ive repaired a couple now for that. however all-off im not sure.Re: adp8912 smeg not heating.
applying a 12volt battery to coil the relay was clicking but not switching. soldered in a new relay and job done.
once again many thanks
kRe: adp8912 smeg not heating.
hi thanks for the reply.
yes i replace quite a few relays. the coil is okay but i think ill open it up for a look and solder a new one in regardless.i will let you know what outcome is
thanks
kRe: Rangemaster Dishwasher RDW459fi/sf
if this was a beko made machine then occasionally i get called to circuit boards where the heater relay has stuck in the on position. a good clue is switch it on at the panel and without selecting or starting a cycle, you will hear the water in the heater start to boil. checking the relay would of course apply to other brands but not as common. i believe yours is a Haier
hope it helps
Re: Bosch dishwasher E24
ive had e24 a few times which turned out to be stuff clogging the main spray pump, but ive also had it for a worn spray pump as well.
Re: Neff dishwasher cover
I normally use my long nose pliers opened out and apply very gentle pressure until it starts to unscrew.
Re: whirlpool AKZ161/03/IX oven
pls let me know if you get this fixed cos ive just taken an identical call over weekend.
many thanks
kRe: hotpoint fdw60 leaking
sometimes the hinge pin drops out. the door may still appear to operate ok but is actually slightly out of alignment. other than that ive never had many leaks from these doors.
Re: siemens sn66mo54gb
I know you say you’ve had baskets out, but did you try it with them out? I got suckered once by the big grab handle on lower basket. it had gradually bent outwards putting pressure on door which was ok until it heated up. simply bent it back inwards and problem solved. had it at least three times since.
Re: Hotpoint dryer motor bearings
from memory 2007 seems to ring a bell. you could also dismantle the one you’ve got and read it off the bearing shell.
