[knobs]

Re: creda SO 77 EEX oven

That was the fault thank you very much,this oven uses a manky plastic tangential fan.
customer well pleased,seeing as it was a christmas eve call.
thanks again
colin

[knobs]

Re: creda SO 77 EEX oven

booked in for next week will try that ,many thanks

[knobs]

thanks ,will check both ,bet its the mod !!!!!!!!!

[knobs]

Re: Trying to identify Indesit Single Oven

i also find that you can get away with a totally different element,just bend it into shape,slide it in,has always worked for me

[knobs]

Re: Leisure Rangemaster 110 Timer

you could try rangemaster themselves ,they have in the past been very helpfull.
tel no 08707895105

[knobs]

thought so,many thanks

[knobs]

Re: beko wm wma765s

Been to a few of these,seems the machine gets a bit upset if the pump is bloked or jammed.
The pump runs for a second or 2 at the start of the prog ..if it doesnt the start light flashes

[knobs]

Re: kenwood cooker

Done few of these,the first one had me going a bit !!
pull the oven out ,take the back off ,you should find 3 screws that should be holding the floor of the oven in place,there should be the same at the front as well.it can be a bit of a job to pull out the floor,i found if i use long nose pliers at the back right hand side of the floor and pull up,it usually works.
i think its the same cooker as a CDA, once the floor is out its easy to fit the new element.

[knobs]

Re: Hotpoint FDW80

No, on the known error codes list its water triac (call an engineer) .
Anyway,the machine works ok now,

[knobs]

ta

[knobs]

a quick fix ,if the(knob) shaft is split along its length
try zipping a bag tie around the shaft ,works a treat

[knobs]

its usually the knob shaft that splits .should be an easy repair

[knobs]

get two oven themometers and take the mean avg
of both,in my experiance aeg ovens tend to read a bit low

[Author]

Posts