Forum Replies Created
-
Posts
-
You’ll need to break out the measuring tape as Tecnik was owned and operated by Moben who collapsed a decade ago so, that info no longer exists.
K.
I will try to find out but, luckily I can see that as here isn’t really the place for that but no matter I am checking for you.
But if the hood motor runs slowly or fails to start, I’d try the capacitor firstly and go from there.
K.
More if you factor in how long the average Junior went on for versus a piece of plastic Dyson will survive in use for.
K.
That could be caused by a number of things, sensor, board, fan motor or airflow in it. No way to be sure without checking stuff really.
K.
It will be controlled by a regulator or a thermostat, depends on how it’s setup.
There are over 100 versions of that model, determined by the serial number.
K.
Sure, it’s stalati@ukwhitegoods.co.uk
K.
If you disconnect a bayonet fitting it’s fine, those are intended to be disconnected by consumers so they can pull stuff out and clean.
Beyond that, on dual fuel, it’s a well grey are, discussed many times including by the WTA with Gas Safe and the HSE and no clear guidance has been forthcoming. Basically, nobody wants to put their head on the block.
So long as you do not break or interrupt a gas supply or carrying part then, technically, you should be okay. But it’s not a dead cert.
K.
