Forum Replies Created
-
Posts
-
Re: plastic washing machine tanks
Manufacturers using these sealed up tubs should be taken to task over it.they must be the most environmentally unfriendly part ever made. Just wondering if any clever person has found a way to cut them open repair and reseal them yet.
Re: Re pipe clips
Thanks for that info just been on ebay and ordered a set great stuff cheers Larry.
Re: Zanussi ZWF1430w W/M
Thanks George when the leds start flashing does this mean the machine is reset and should go into a programme then
Re: monthly news letter
Ah that explains it thanks i will look forward to reading it in the future Thanks again .
Re: Refridgeration Repairs
Thanks for the info I was lead to believe that you couldnt weld the new stuff as it was highly flamable.
Re: Refridgeration Repairs
Hi ive been looking to see what kit ive got left for regassing i can only find a set of gauges in the workshop is there secondhand kit around for sale anywhere also is it right you dont solder pipes anymore but use a crimping tool which again i will have to buy.Larry
Re: Refridgeration Repairs
The training sounds good i’m in Hereford but would gladly travel up to Boston to get some up to date training and for free what could be better than that please let me know the dates its taking place ,Larry.
Re: whirlpool AWO3751/5
sounds like it could be losing the power supply intermmitantly
check plug and socket on wall try it in a different socket just to see if that helps ,Larry.Re: Samsung F/F RSH INBRS
I’ve been out to this samsung f/f this morning and tried to get the panel off at the bottom off the fridge to check the sensor, But it wouldn’t come off its got 4 screws holding it but seems to be stuck on as well didn’t like to pull to hard as I’m not sure what’s behind it altogether or should I be going for the longer panel which starts at the top,Some help needed if poss Thanks Larry.
Re: Manufacturer Seeking Agents
I Have just read this ad and i cover HR post codes would this be one of the areas an engineer is needed for ,Larry. phone no is 07974402273.
Re: Whirlpool K40 icemaker
tried all that still wont work when the top stat cuts in still gets 24volts wondering if it could be that small black box at the bottom on the back of the machine not sure what it does
Re: AEG L62600 W/M just stops
Yea the brushes are ok ,its odd because ive never known a door lock work then break down in the middle of a programme last night it stopped for about 2 or 3 mins after about 15 mins of the programme then started up again it seemed to happen just before the heater switched on thought maybe its a relay on the board.
