[laurenceuk]

Re: Need Guidance Wiring From Sunvic to Diamond – See Photos

Thanks to all.

It has been a good education.

Laurence

[laurenceuk]

Re: Need Guidance Wiring From Sunvic to Diamond – See Photos

Thanks Dave,

This is a single and not a double as indicated in the sticky post.

It is a sunvic stat as opposed to diamond – I am still unsure where to put the
load for this and if I need to use the link. 😳

Laurence

[laurenceuk]

Re: Nardi FEA0614 Oven – Never Heard Of It – Need Fan Motor

Thanks Fellas,

Very Much appreciated.

Laurence

[laurenceuk]

Re: Zanussi WJD1257W Error E90 On Tumble Dry – What is E90?

Thanks for your help folks

Very much appreciated

Laurence

[laurenceuk]

Re: Schreiber AMP6321 Fridge Door Hinge Needed?

Thanks Dave

Much appreciated

[laurenceuk]

Re: Tried Everything (nearly), Still Problem, Help! HVR HC12

Oops

It is a Hoover HC6120MUK

Laurence

[laurenceuk]

Re: Confusion Over Drum Shaft for H/point WMA58 – Which One!

Thanks for clarifying that Brian.

Much appreciated

Laurence

[laurenceuk]

Re: Confusion Over Drum Shaft for H/point WMA58 – Which One!

Hi Brian,

Thanks for your response.

Just to clarify, the shaft 1604477 (30mm) is the part listed as obsolete at
Connect but you say can be ordered from Qualtex. Do you have a phone number?

The 1604290 shows as the 35mm shaft on Partfinder, which is not the one I want.

I think I am right in this.

Laurence

[laurenceuk]

Re: Confusion Over Drum Shaft for H/point WMA58 – Which One!

Thanks Andy,

Looks like drum replacement then 🙁

Laurence

[laurenceuk]

Re: Bosch Fridge Hinge – Which One Is weakest?

Thanks Gegsy,

I thought that would be the case but it helps to get a 2nd opinion, especially as Connect only carry the bottom hinge – strange that.

Laurence

[laurenceuk]

Re: Whirlpool ADG7540 Dishwasher Not Heating?

From the table you kindly posted Gegsy I would hopefully feel confident
that it is the NTC that is the culprit.

The customers NTC reading is 4.6K ohms at ambient temp. From the
table, the PCB is assuming that it is already at temperature hence the reason
it completes the program normally without heating.

Thanks again

Laurence

[laurenceuk]

Re: Whirlpool ADG7540 Dishwasher Not Heating?

Thanks all,

Thats a great help – gives me the direction to look towards.

Laurence

[laurenceuk]

Re: Whirlpool ADG7540 Dishwasher Not Heating?

Hi Gegsy,

Thanks for your response.

That sounds exactly what is happening here.

I asked the customer to put the m/c through a prog again and watch for
lights flashing but it ended with no fault indications showing and it had
not heated

What is the normal NTC reading – if you have it.

Thanks again

Laurence

[laurenceuk]

Re: Diplomat ADP8332 ( Whirlpool Clone)

Thanks John,

Keep it as a spare – yes.

OK

Laurence

[laurenceuk]

Re: Freezer Thermostat – See Photos

Hi Bryan,

Thanks for the info.

I don`t fit many freezer stats funny enough. Can you give me a number.

This one is contained in it`s own little box at the rear.

Laurence

[Author]

Posts