Forum Replies Created
-
Posts
-
Re: samsung built-in oven BF64CBST
Hi peter
The first thing i would check is the terminal block where the mains cable goes in to the back of the oven. but make sure you have turned the power off first. i have seen this where the wire can burn out and would stop power going to the oven.
Re: LG F1403FD washing machine,noisy
If you have a little yellow plastic jet inside the top part your door seal. They can clog up with fluff and all sorts that runs on a recirculating pump. If this is blocked up it puts pressure on the pump and make that type of sound. Try to clear this and that may sort it.
Re: Advice and opinions appreciated
10 year guarantee against the breakdown of the washing machine drum, outer tub, axle, bearings and * brushless motor. does not say if that include engineer visit and only fixed by Miele? not being funny but the look of a Miele washing machine isn’t the best looking in the world.
Re: Gorenje GV62110 Intermittent E3 Code
Most thermostats are under the machine and have two wires connected to them some are easy and some are a pain but can be done.
Just remember to turn the power off first.
Re: Fixing baumatic BD1631?
Sound like your drain pump is blocked, this would give this error code as well i think, try taking the waste pipe out of your drainage pipe and put it in a bucket and start the machine and see if it drains water out.
just remember that the first think all dishwashers do is drain first then fill
Re: Advice and opinions appreciated
Firstly. Miele over rated and don’t last as long as they use to. If you think about it, Miele price £1500 and last about 6 to 8 years when an Indesit last about 5 to 7 years and costs about £300. So if you do the maths I’d going for that. My fav is lg direct drive
Short term if your Beko fridge packs up. I’d say get Beko again for the short life they have, But for long term lg side by side American Fridge Freezer (R600a gas)
And yes to white knight, they are really good.
The machines that I have listed are very good but at the same time all have there little faults in one way or another, ever your lucky or not but if you look after your machines the machines will look after you.
hope this helps
Re: Beko WM7147W wont wash
You could try and have a look and see if it can be soldered but i dont think so as it is more then likely to be a component on the board.
Re: Whirlpool ADG 332 – 4 Flashes
machine is not draining water. check waste pipe and pump. most of the time its the pump that has something in it.
Re: continuous end of cycle bleeping
in the bottom of most dishwashers is a float sensor that if the machine has water in the bottom then the sensor kicks in and stops the machine doing anything. pull the machine and tip it backwards (there maybe water when doing this) and then stand it back up… try starting the machine and see if the machine starts working, if it does then you have a leak coming from somewhere.
let me know
Re: Diplomat HJA 8640 Top spray arm not rotating or spraying
check that the rubber washer on the spray arm is ok and also check the nut at the back of the top spray arm as there is a rubber seal the the draw should lock in to. the presser could be low due to water leaking from these points
Re: Whirlpool ADP4501
theres a blockage somewhere as the pump is trying to hard that why it stops and starts i think.
Re: RSH1DBRS samsung lcd display problem
can you tell me which line is flashing as this would tell me what is wrong?
