Forum Replies Created
-
Posts
-
Re: zanussi washer dryer
New door lock, it gets trapped against cabinet as mechanism on the inside! Genius
Re: My fridge is defying logic
Mark,
That damn fly on screen thing is so so very annoying!!!
Have tried to ‘shoo’ it off my screen twice tonight already.
PS Where did you get it?
Re: AEG Fridge 927966320, 3774-6KA, FLEC Control
new pcb mate usually light flashes when compressor running
good luck
Re: I ripped their floor vinyl.
old fashioned and simple piece of 5mm hardboard shiny side down …..magic
Re: Zanussi fl-1082 pcb gone – worth repairing ?
would strongly sugest an engineer be called because the board has blown for a reason, this needs to be investigated or it will blow the new board/timer…. and yes its all one unit.
Re: Zannussi FJS1225W with Fault code E40
worth looking at the latch (hook like thingy) on the door itself, it can simply be the latch is not springing back properly so not activating the door lock everytime…………….. power off even though its just the door!!!!!
Re: Dead Zan. ZWF 1011W
had one similar the other day turned out to be short circuit on the motor tacho so board thought drum turning. just an idea!!??!!
Re: Zanussi ZEBF249W f/freezer
if its the one i think there is an air channel on the back of cabinet directly below the evaporator this will be frozen
Re: zanussi w/m ZJD1285
stab in the dark, but is pressure chamber nice and clean or any holes in pressure tubes?
Re: tricity bendix aw1400 end light & beeps
disconnect the power before even reading this……. it could simply be the door catch that goes into the interlock is not quite springing back enough, it this is the case the door needs to be split and you will find a metal rod has come out of door catch mechanism, failing that a possible pcb fault.
good luck
power off please it hurts!!!!
