Forum Replies Created
-
Posts
-
Re: AEG built in fridge with electronic control (A headache
unfortunately a new board is required, light will flash mainly when compressor is running if left the supply to compressor will be lost and then obviously no cooling.
Re: Zanussi F1245W PNC 914792005/00
No problem, we learn a little bit more everyday, one day ill know what im doing completely, well i hope so!!!
Re: Zanussi F1245W PNC 914792005/00
hi, this is completely normal, no fault, it is fact just doing the same programme but at a higher temprature. this timer if put on a will move through cycle and do same wash action just higher temp
Re: AEG Favorit F5050 D/W
Youll be right with cleaning out the blue syphon tubes, if the tubes are blocked it will cause erratic sticking faults.
Re: Baumatic BDW5 dishwasher flashing lights!!
i can help with negative temperature coefficient 😀
Re: Fitting Zanussi door seals
put washing up liquid on your hands, rub it in both sides put spring on the bottom of seal first, then pull upwards no special tools required. 😛
Re: ZANUSSI F/F
Would say your fault lies with the evap. sensor but replace the pair and youll be fine.
Re: ZANUSSI F/F
Depending on model this could be the fault, but check defrost heater is ok and if applicable the defrost timer is advancing and not stuck in position.
Post the model number and will try to help further.Re: AEG SANTO1688
with my experience the sensors will be fine, unfortunately a new main PCB will be required.
