[matrixresonator]

Also make sure you’ve fitted the right valve as there are a couple of types and they aren’t interchangeable.
You need 11033896 (superseded from 00631199)

I’ve heard of a few rare occasions that the dispenser has caused this but I’ve not seen it personally. Otherwise as above check wires and if that doesn’t work then it’s PCB.

[matrixresonator]

I’ve never had this fault and its not been the valve at fault. Easy repair.

[matrixresonator]

That’s all I have.

[matrixresonator]

I use this one, does everything I need:

UT533 Insulation Multimeter – UNI-T Meters | Test & Measurement Tools and Solutions (uni-trend.com)

[matrixresonator]

Manusoft says 2859920030

[matrixresonator]

Door lock error. Also check wiring on motor they can get damaged and cause weird things to happen

[matrixresonator]

These machines are notorious for broken loom wires in the door.

[matrixresonator]

I’ve had a couple of those machines leak from where the air break connects to the salt tank, replacing the O rings has fixed most of them.

[matrixresonator]

This time of year is always quieter, I’ve just looked at my accounts though and for April to July I’m well up this year compared to last year.

[matrixresonator]

Heater showing 2976680600 or 2983230100
PCB 2969848101

[matrixresonator]

Motor 2843120300
Motor PCB 2500001000
Mian PCB 2858195330

[matrixresonator]

A lot of the short ones don’t have a bracket to slot into, but yes over tightening it can cause it to pop out.

[matrixresonator]

Common fault for them to break there.

[matrixresonator]

Have you meggered the element, I’ve seen a few machines where slight earth leaks, while not causing the RCD to trip, will play up with the door lock.

[matrixresonator]

I’ll DM you.

[Author]

Posts