Forum Replies Created
-
Posts
-
thanks dave. had to rack my brains because these machines are old now but found there were 13 flashes which I seem to remember that was a tacho fault it use to keep the motor running at full speed so stopping the heater coming on any one know what reading i should be getting from the tacho.
yes ! thanks dave. have done all that. I might lend her a m/c and bring hers back to the workshop and play .
Hi dave she said it started flashing halfway through ( she thinks) now it dose it as soon as it is turned on at the plug? they say it could be an overheat problem so I tried another thermistor still the same.
H could be a number of faults one being the turbidity sensor H usually has something to do with water intake
could not see anything obvious on the lower board but did not take the door apart to check the touch panel because it wasn`t showing any signs of life.
hi dave yes I can see they could measure the restiance to see if the motor is pushing water around but tha doesn`t explain why it stops and gose back to 00 and also why the metering tank stays empty.
sorry dave, missed your last post we scraped the machine as she couldn`t wait but as far as i remember the heater checked out fine.
been back checked the power board cant see any blown components all caps seem fine. Any Beko engineers out there?
They have been run by the banks for a while hence no stock ! its going to take time for them to get there acounts with the manufactures up and running again so don`t think there stock levels will be getting back to normal for quite a while
you might find that the water valve is energised for a split second during spin hence water in drawer . could be a valve or a bad earth
Dave
would it be possible for you to email me the fault codes for this m/c also
ps I have changed my addresss to mikehaleywork@outlook.com many thanks
mike
