Forum Replies Created
-
Posts
-
thanks all and yes dave tacho is 225 but will go back and check thermistor if ok will remove board.and have a play what have I got to loose thanks again mike
thanks dave . what a ball ace of a job fans seem to run ok out of the module and there does not seem to be anything blocking or fouling the fans! will try another avenue because a module/induction unit is £1000.
dave a question first can the fans be replaced because I can`t find a part number for the fan only the module.And second we are talking about the fans in the main unit fvla057472
One for you all to file away two red thin wires go to the front thermistor . two thin yellow wires go the thermistor on the back of the condenser box BUT the two green wires go to a float switch which was stuck closed hence the fault shown. Sod to do as you have to take the drum out .Hope this helps mike
thanks for the info Dave she was a bit right not 12 flashes but E12 and that is something to do with a pressure switch but I can`t find a pressure switch anywhere and I don`t know why there would be one as the water container is underneath the condenser.DO you know the value of the thermistors ?
again thanks for the information mikemine turned out to be the fan oven element It only did it occasionally and usually when turning the oven off.
thank you for the diagram could you supply the part number of 1442 thats the pin that holds in the single damper.
is this the one that cuts out the fan and element when it gets to temp then brings it back on when the temp on the thermostat drops. if it is then it caught me out thinking it was a fault.
