[mikehha]

thanks for that dave at least it will give me a start after I have figured out the English. But they still don`t say how to get to the screw that holds the inner hinge in? It also seem a bit of a pain if you have to take off the top and burners just to take off the side. O and of course the back panel !
thanks again mike.

[mikehha]

hotpoint c00310991 about £8.00

[mikehha]

try the overload cut out on the heater duct

[mikehha]

dave hi I have a 4986er1005c I don`t know if this is any good.

[mikehha]

this takes me back to when we used to braze the suspension brackets back on to servis tubs. those were the days

[mikehha]

it seems to me that if you order through parts center its next day I dont think they can be bothered with trade. Still waiting for my delivery !

[mikehha]

to all you engineers with this fault (which seems to be quite common) I have just fitted a tacho off a hotpoint induction motor also while I had it apart I found that Vestel/yedek washing machine motors have the same tacho. All seems good at the moment !

[mikehha]

thanks dave. pnc no 911539205 00 If it is a tacho then the motor I have 140074403035( which was sent by zanussi ) won`t work because it has no tacho

[mikehha]

andy check the dryer heater these give problems on this range

[mikehha]

according to whirlpool F02 is a motor circuit fault so if nothing wrong with motor I would presume board.

[mikehha]

no not thick just not engineers. have never been out on the road so never see the problems that we get.

[mikehha]

yep 0402 different part numbers do I take the chance and order the cheap one ? decision decisions!

[mikehha]

I found them dave part no 1881090200
thank you mike

[mikehha]

Opps no that’s not them the one I want are right angle bracket (small ) that fit into slots in the outer cabinate support so you can adjust the tension on the springs

[mikehha]

Thank you Dave just ordered them

[Author]

Posts