Forum Replies Created
-
Posts
-
Re: Sub zero
The cooler has an on off switch but it’s on and temps set
Or is it some kind of demo modeRe: Sub zero
It has 2 compressors and one is not plugged into any thing
The light in the wine cooler light up it the display to alter the temp that appears dead I’m hoping someone will see the photo and know where they plug in the fridge has a large glass door at the top for wine and the 2 stainless steel draws for beer all lights are lighting up just 2 temp displays dead thought maybe just unpluggedRe: Bosch Exxcel SMS58E22GB/80 Dishwasher no go
Would go for bottom board have you removed module and removed from plastic casing to examine
Re: Bosch SMV53A00GB/34 Dishwasher
Low insulation will cause this usually from the heat pump dues to water leaking on it
Re: Bosch washing machine WFO (motor PCB)
Jumping to 1 minute means the appliance has given up on what it is trying to achieve ie unbalanced load , no heat, are the most common 1 minute is what appears when the machine can’t give a fault code (time out)
I hope this makes sense
If the 8 kg model starts the wash again I would suspect this is due to over foam detection too much powder although this would usually also flash the washing symbolRe: Fisher & paykel dd603i not pumping
This was a tiny module under the pump which only had a triac mounted on it sorted
Re: neff warming draw won’t close fully
Does the draw function?
Some have a locking device the older models which I think is the one your talking about should just push shut without locking shut so the only thing it comes into contact with that could possibly stop it going back would be a bent pin on the rear of the draw I take it the draw is held on via two screws I take it these are in I can only suggest removing it and looking closerRe: Fisher Paykel DD603
hi guys also had the same problem and not repaired many of these put it on and motor turns but seems a lot slower and quieter compared to other draw i tried swapping rotars but still the same won’t drain and then beeps before fill starts
customer said the none working draw fills up when the other one drains this makes me think a blockage maybe but the noise difference makes me think its trying to wash ?Re: north west based work
I take it ur not north west based rub?
Are you looking to employ some one?
Mike
