Forum Replies Created
-
Posts
-
drill a small hole each side of the element (carefully) and fit a cross support under the element done several no comebacks so far
was using whirlpool branded ones very often takes out the breaker all but stopped fitting them due to recalls
I wonder how we stand when fitting a replacement interlock to a hotpoint which new parts maybe affected as these interlocks fit many models
Thanks Dave yes i did a part number enquiry with connect and they came up with this part i did not believe the hinge could be part of the door as the lower hinge is available problem also is this door is obsolete looks like i will have to get inventive seems crazy to scrap a cooker with such a small problem really did not think Electrolux could sink to such a low
if it is the one with the roller between the two ovens i seem to remember removing a panel from the front
is it the same as the rangemaster 2 threaded screws behind the front panel removes the element retainer panel
connect are showing one board in stock but limited stock is it possible to run a feed from the selector switch
Re: zanussi zkc5540xs 943206179 grill hinge
as far as i can tell its under the side panel i got a call to a similer cooker using the same part but when i went to fit it a realised it was all gas not dual fuel as the customer said. no access from under the hob or from the back but the screws for side panel are on the inside so need the back off problem with me is the grill gas pipe goes through a hole in the back cover so had to pass the job to gas safe engineer hope this helps
Re: Beko FRIDGE FREEZER
probably but you need to check the stat capillary is in contact with back of fridge or if internal that part of fridge is cold enough
Re: Bosch WTE84105GB/31 stops after 10 mins
had a similer machine last year it was fabric caught up around the heater element or maybe open circuit element
Re: bush dryer v7sdw
argos budget dryer sounds like air flow blockage vent hose or hole through wall maybe or fan problem
