Forum Replies Created
-
Posts
-
This model has two separate drying programs (4th and 5th programs down the blue programs on left of the control knob)
Rotate the control knob to select ‘Cotton Dry’ or ‘Synthetic Dry’ program.
Push the Drying button to change options (dryness level or manual drying time)
Then press start.Murv…
No pump on this one. Water getting thru to tank. Condenser and housing clean. Thought I would check for full signal at pcb before stripping the drum out to see whats going on.
My email is murv@sparez.co.uk
Thanks.As Dave said, if it’s an early board it will most likely be a shorted Q29 or Q27. Can be Triac with VDR protection or an AC Switch in these positions.
Murv…
Can’t think of anything but the module. Do you have a matching one from an old machine that can be reprogrammed to suit?
As Dave said it’s best to check the shaft and stainless collar before ordering a kit. If you get stuck I list this kit in workshop stock.
Murv…
The L914WM20 looks like it’s made by Vestel in which case the L914WM18 pulley won’t fit.
As Don said it’s best to drop an email to the shop with the full model and the long serial number from the rating label.
Murv…
Just tighten the 10mm heater retaining nut in the centre of the heater bracket. This squashes the rubber heater gasket creating a seal to the tub and to the sensor.
Murv…
