Forum Replies Created
-
Posts
-
Re: Zanussi ZWD145815 Washer Dryer – does nothing
Hi mike,
I’ve tried that to no avail mate,
The only problem i have noticed is the wiring for the thermistor that fits into the bottom pipe between the condenser and the tub was broken which i have temp fixed but doesn’t seem to change anything. I’m really baffled.
Any other ideas?
Thanks
OllieRe: Bosch Washing Machine WFF2000GB/12 FD7706
The element was open circuit, Changed it over – all appeared fine,
but the customer has just rang and now says it runs through fine on the cottons and whites but on the easy care setting the pre-wash light flashes after a little while on that still.
What am i missing? 😕Re: Bosch SGS4472ZA/17 FD8403
i wish it was that bud, but i’ve held the 2 buttons to reset it numerous times. think i’m going to have to go with board.
Re: Bosch SGS4472ZA/17 FD8403
fingers crossed, Thanks for your help martin, much appreciated. Just cant understand why the 50 degree wash states 20 mins.
Re: Bosch SGS4472ZA/17 FD8403
I’m certain i did martin but i’ll have another check monday – worth a go as its really bugging me. lol. I’ve just spoke to her and the fast wash has run through fine again this morning – strange.
Re: Bosch SGS4472ZA/17 FD8403
Is that that sensor on the top or the back connector to the little board? if thats loose could that send it funny?
Re: Bosch SGS4472ZA/17 FD8403
Sorry martin – i just went back to fit it, They said that it wasn’t heating – so i metered the heater and it was open circuit – changed it -thought it was happy days but ohhh noooo.
Re: Bosch SGS4472ZA/17 FD8403
Update:-
Just been and had another look – Its heating.
Basically i put it on a fast 35degree (displays 31 mins) and it went through fine down to 6 mins then jumped to 2 mins then finished off to 0mins ok -I did notice there was no drying period for this but assume this is normal as its a fast wash ?????
When i select the 50 degree eco wash – the display says 20 mins – which surely can not be right, it does however wash down to 3 mins then jumps to 167 or 196 mins
On the auto it seemed to start off ok then again jump to 196 or 199 mins.
I’m thinking the pcb has to be corrupt doesn’t it?
Heeeeeelllllpppp. lol
Thanks.Re: Bosch SGS4472ZA/17 FD8403
Good thinking but it’s definitely washing, When i left it earlier the spray arms were going round fine etc, The only thing i’m thinking is maybe the heating bit on board had has blown too, Anyone?
Re: WT741G /2 Burning smell from pcb
that part of the connector that is discoloured from burning out the previous board is the red that goes to the pressure switch. Is there a way to test the pressure switch and could this be a possible cause? Connections all seem ok and theres no breaks in the cable.
Re: WT741G /2 Burning smell from pcb
Both read fine, no obvious breaks or anything, all insulation resistance reads o.k, Any other ideas, I’m really stuck on this guys.
