Forum Replies Created
-
Posts
-
Re: Fan Oven not heating up
We are not allowed to give specific instructions for a variety of reasons. Plaese check:
http://www.ukwhitegoods.co.uk/modules.p … pic&t=4361Sufficed to say that removing the rear inner panel of the oven (with the power off) may lead to enlightenment.
Regards,
Penguin45.Re: Zanussi carbons
50216397-00/5 gen, 12-ZN-03 Europart. Should have a Sole motor in it according to TDS………
Chris.
Re: A Siemens wm50200gb/14 headscratcher
Check water level control Tony – can run on if it thinks it’s still full at programme end. Otherwise, being an AKO timer/digiboard combined unit, a lot of the Hotpoint logic can be applied to fault finding.
Cheers,
Chris.Re: Bosch SGS43C12 – never ending wash cycle
Is it heating Jim? Programme will pause until wash temperature is achieved. At nine months old you are still comfortably within your guarantee period, so get BSH on the case.
Regards,
Penguin45.Re: Mr Hasn’t got a clue, needs help (Diplomat ADP8332)
And don’t be tempted by the 3-in-1 tablets that claim to do it all for you. Stick withe separates and it’ll work fine.
Regards,
Penguin45.Re: Patience
They do it to me too GB; they all know I slip out for a pint at 10.30 and all sorts of stuff appears.
Chris.
Re: Hotpoint WM83P Door Seal Replacement
Take the front off for easy access. Power off………. :plug:
Regards,
Penguin45.Re: Hotpoint / Creda tumble dryers not heating
Which washer dryer are we on about? For 10 years at least we’ve had a heater box with one operating stat and one safety cut-out on it. Or are we on about the Indesit derived stuff?
Chris.
Re: Hotpoint / Creda tumble dryers not heating
If this red spot stat operates 10c higher, isn’t this closing the gap to the 180c safety, thererore making it more likely to trip? Doesn’t make any sense.
Chris.
Re: Combi fridge-freezer: Freeze Broken, Fridge OK
Model number would be a good starting point to help the fridge chaps make a diagnosis………..
Penguin45.
