Forum Replies Created
-
Posts
-
Re: smeg DWF64 SSE
2-3-4 isn’t a code – you’re probably looking at a corruption issue. Suppressor, dispenser solenoid, even the motor capacitor are all suspects. If none of them sorts it, pcb………..
Chris.
Re: TEKA DW6 FI – Unable to reset
Decor door, kick board and lower cover plate off – power off as well. That should let you see into the base of the machine.
Penguin45.
Re: TEKA DW6 FI – Unable to reset
Flood protection activated – you may well have water in the tray under the machine. Drain off to re-set. If you get a recurrence, find the leak.
Power off first, please.
Penguin45.
Re: ADG 7550 Tripping out
That’s what’s underneath – heater is in the shop, HERE.Stay safe, power off if you intend to do this yourself.
Penguin45.
Re: Britannia oven, grill element
Dave_Conway wrote:Britannia Living Ltd.
Britannia House,
281 Bristol Avenue,
Blackpool
FY2 0JFt. 01253 471111
f. 01253 471136http://www.britannialiving.co.uk/
That should be enough I hope 😀
Dave.
Chris.
Re: Indesit DI620 1 & 3 Flashing
Filter block error – usually high pressure p/sw failed or gunged.
Chris.
Re: Simpson 5.5 always out of balance
36 S 550M……..
Top loader – there will be transit packaging.Penguin45.
Re: ADG 7550 Tripping out
Almost certainly the heater has an earth fault – switches on after about ten minutes.
Penguin45.
