Forum Replies Created
-
Posts
-
Re: Powerpoint tw36fi dishwasher does not start
Powerpoint is a name given to proprietory badged kitchen appliances, rather in the way that Diplomat and Hygena were MFI brand names. The agents on this instance appear to be:
Shomar Ltd.
Unit 9 Western Ind Est, Dublin 12.
Tel: +353(1)4509150Hope that’s some help,
Penguin45.Re: Start/Run capacitor for Zanussi Z9191T
16uf from memory. Wire the terminals diametrically opposite each other and you won’t go wrong.
Penguin45.
Re: Ikea / Whirlpool DWF 406 W – Error code 02
F2 is flood protection system activated – the base tray under the machine probably has water in it. Drain the tray to reset. If you get a repetition, find the leak…..
Power off first.
Penguin45.
Re: CANDY COND DRYER GODC218
Plungers on the tank and condenser ducting blocked/jammed/broken would be a good place to start.
GOC218-80, BTW (or you’ll never get parts…)
Chris.
Re: Hotpoint BWD 129 – flashing lights midway through cycle
Two socks…….. 😆
Seriously, filter not located correctly; tub to pump hose twisted/kinked upon refitting; eco ball pushed up above collar can all stop it emptying. If the pump’s not actually running there may be a foreign object in the impellor itself or the wiring is disturbed from your previous work.
Penguin45.
Re: Drum noise on spin –
Drum and shaft as an assembly – about £95 – p/no 97910285. spares@ukwhitegoods.co.uk will get you one promptly if you wished to go ahead.
This job will take a repairer the best part of two hours. The entire tub assembly needs to be removed from the machine and split, so the cabinet needs to be stripped as well.
Labour rates vary widely across the UK – up ‘ere in’t north, you’d be looking at £75 from me – £45 for the first hour and £30 for the second. Dahn Saaf you can probably add on half as much again.
If you do do this yourself, take pics and make diagrams……
Penguin45.
Re: Whirlpool AWO-D5516 code f26
It means that the triac switching the pump on and off on the pcb has failed. However, you should check aquastop (if fitted) and p/sw functgion as well.
Chris.
Re: Zanussi dishwasher ZDT 6053
Heater may have failed. Connections at heater may have burnt out. Most likely burnt out solder joint on pcb in control panel.
Power off if fixing this yourself.
Penguin45.
Re: SMEG DWI 410 no water from the spray arms
There are two solutions to this, both of which involve the use of No.1 earhole.
After the machine has filled, can you hear a faint humming noise? If you can, there is power going to the motor and the capacitor may well be the solution; unless the pump is jammed by a foreign body. You’ll need one of THESE.
If you can hear the motor whirring away, the impellor may have sheared from the pump shaft and may not be moving the water. A pump housing and impellor kit may be required.
Stay safe – power off if working on the machine.
Penguin45.
Re: The passing of Sir Bobby Robson
That’s very sad. A true football man and a gentleman to boot.
Chris.
