Forum Replies Created
-
Posts
-
Re: Instructions for White Westinghouse Electric Oven needed
Two chances, they both end in “all”. THIS ARTICLE may be of some use.
Find a model number for the vaguest, slightest hope of a proper answer.
Penguin45.
Re: Belt Drive Replacement Whirlpool AW 7814 AL Dryer
Nope, condensor, demolition required. Vented dryer is under 15 minutes.
Penguin45.
Re: Aeg T560 tumble dryer lift pump make noise and low heat?
Heater is damaged, new one is part number 1120990-76/5.
If the pump is noisy or intermittent, water may be thrown into the heater, so the pump must be replaced as well – part number 8996474080-86/9.Penguin45.
Re: Bosch WFF1401 Not turning (Replaced Brushes).
Using your test meter, meter across the motor terminals. They are in pairs and you should get a reading in low ohms across each. If that’s OK, blown tracks on the timer/pcb is a distinct possiblity; triac on same pcb my have failed.
Penguin45.
Re: ASHES
Hmm – cricket, volcanoes, aeroplanes. Cricket, aeroplanes, volcanoes. Volcanoes, cricket, aeroplanes…
Not seeing it, Mike.
Chris.
Re: Bosch WFK2201:re-fills after wash cyle complete
It’s an early digital machine – it more or less has to be a logic error, so you’ll need a power board – a snip at £249.81.
Penguin45.
Re: new machine..but what to pay…
If you buy the Baumatic we’ll never speak to you again – ever.
Chinese rubbish.
NEFF and Bosch are the same base unit, different badges. Decent quality, decent warranty, reasonably reliable and most issues can be sorted easily.
Fagor is a slightly unknown quantity at present. Since the merger with Brandt they’ve been a bit quiet, so not too much known about the current machines. They’re not Chinese though, which has to be better.
Penguin45.
Re: sgs45c02gb/02 bosch d/w
Motor unit will disassemble if you need to replace the bearings. You need to mark the shaft to ensure that you locate the new ones correctly.
Chris.
