Forum Replies Created
-
Posts
-
Re: Bosch SGS6962GB13 top basket not washing properly.
Water diverter unit attached to the heater will have failed in the “bottom” position. This is almost certainly a mechnical problem and will require the heater assembly to be replaced. Nasty, nasty job as the entire stainless cavity has to come off the base unit for access.
Penguin45.
Re: Whirlpool DWF 405 – constant flashing, NTC seems OK
Strange to say, despite your testing, the ntc sensor is almost certainly the fault. They are extremely sensitive, as is the computer board. Changing it will almost certainly solve the problem.
Penguin45.
Re: Whirlpool ADP903 leaking from underneath
I can only suggest that you remove the front lower cover plate, get a torch and observe. Niggly little drip drip problems which aren’t the drain or fill hose can be an absolute pain to track down.
Penguin45.
Re: zanussi dce 5655 help please
The single most likely cause is overfoaming – if the customer is putting a multifunction tablet into a a table-top machine, she’s overdosing it by a factor of three every time.
Otherwise, get the base off, block it up and see if it drips.
Chris.
Re: Alias Haier
I can have a word with UKW member Musket if you wish – he has a Cat 3 explosives licence and has been featured on Scrapheap Challenge several times.
Not bad for my ex-apprentice. 😀
Chris.
Re: Hotpoint WDD960P bearings gone
maltheviking wrote: ❓ Where’s the translate/predictive text button mods?
That’ll be me, then.
f2b = Front to back.
:p45:
Re: Bosch WFF2000 W/M
Circuit through the motor? There is a TOC on the brush plate in-line with the brushes.
Chris.
Re: Tricity Bendix Washer Dryer BW650-worth checking repaira
Your symptoms match thos of the article. The end of the motor is accessible (just) if you remove the lower cover plate. Remove the plug as well, of course.
Penguin45.
Re: Bosch SPS2462GB/19 – no water, inlet valve suspected
A read of THIS ongoing thread should prove informative.
Penguin45.
