Forum Replies Created
-
Posts
-
Re: Hoover HND6515
Element is in the up tube to the top rotors. Remove plastic cover at the bottpm to reveal terminals.
Power off first.
Penguin45.
Re: Zanussi Dryer Element Anyone ???
Took DST off front, typed in the number and it came up as in stock. :hmm:
Chris.
Re: Tricity Sovereign Electronic Parts
Nothing at all listed for these old girls now, sorry. There have been a few broken up and shared out over the years – put 4638 into Search to review.
Penguin45.
Re: dogs
Some years ago I was attacked by a cat through the cat-flap whilst writing out the “Where were you?” note.
Chris.
Re: Indesit D4200 WG – not draining
They weren’t too bad back then….
Possibilities:
1/ Given the time of year, frozen. (Machine now works..)
2/ Old, tired drain pump. Entirely possible, the machine is older than you think. Generic Askoll type motor unit will go straight on at little expense.
3/ Foreign body now passed through.
4/ Dodgy wiring at door pivot point – door outer off to check.
5/ Timer – unlikely; they work or they don’t, there is n’t usually a half way position.Don’t go mad with it – an awful lot of the parts are going obsolete.
Penguin45.
Re: WPL AWO D4505 DOOR SEAL
481246068532 is the actual part number – Masterpart list it at £9.50.
Part numbers are always better than b@ggering about with spurious stock codes.
Chris.
Re: Is This The New Craze?
Possibly the best threadstopper on UKW that doesn’t involve the Mods locking the topic I’ve seen to date….
Ewww.
:p45:
Re: indesit 530 problem
Flood protection activated – water has leaked into the tray under the machine.
Power off, towels down and tip the machine to a good angle to drain the tray.
If you get a repetition, find the leak.
Penguin45.
Re: SMEG DI612 PUMP FAULT
Float switch is a diect mains feed, the pump is otherwise switched by the pcb, so it’s probably not OK.
Chris.
