Forum Replies Created
-
Posts
-
Re: bosch SGS47EO2GB/35 full of water
Two pumps. Drain and circulation. When you start a programme it should drain. Press the two buttons with the dots and the line underneath and it should cancel the programme and drain out. If it does, the drain pump is fine.
Your description points more towards a circulation pump problem. It may be jammed, blocked or seized due to leakage. If it is free to turn, the start/run capacitor may have failed.
Power off for anything other than observation.
Penguin45.
Re: AW23 E34
All the E3- codes relate to temperature, 34 isn’t listed.
Any error code I’ve had to date has been cleared by pressing and holding the start button, then turning the dial back to off and starting again.
Chris.
Re: Neff S5453X1GB/50 Dishwasher not pumping out
If the drain pump is actually running and it’s not draining, there are several possibilities.
1/ Old, tired drain pump. It is after all just a magnetic drain pump motor like any other today.
2/ Blockage in the matrix. Over the years I have had several with bits of glass in the outlet side of the matrix – almost impossible to see.
3/ Drain hose collapsed due to bad install.
4/ Sink couplings – always good for a laugh.The flap valve has never caused me any problems. You can remove it without causing a drop in pump pressure if you wanted to double check.
Chris.
Re: Creda Europa 48105 door catch
Slacken, but do not release, the two screws for the top hinge. You should be able to lift it and release the door. The inner and outer door are held by four screws, two at the top and two at the bottom of the door, IIRC.
Penguin45.
Re: Diplomat SIngle Built-in Oven ACA3200 Serial 0711460090
As a temporary measure, disconnect it completely and see if you get function.
If you contact spares@ukwhitegoods.co.uk with your model info, they should be able to source a suitable replacement for you.
Make a note of where the wiring fits – we won’t be able to help you if you don’t.
Penguin45.
Re: zanussi w dryer zwd 16270w
No timer, John – fully digital. Have sent you the tech manual.
Chris.
Re: Neff S5453X1GB/50 Dishwasher not pumping out
Sounds good so far – correct water level is between the bottom and halfway up the salt cap.
Chris.
Re: They dont build em like that anymore – Part 20
Cras wrote:circa 1955 and is still in use 😀
Don’t do an insulation test on it……….. The old dear might never forgive you.
Chris.
Re: Indesit washer/dryer code 15
Check that the dryer element is connected, the inline thermal fuse has continuity through it, and that there is resistance through the dryer element. Not quite sure what you should get as you’re on 110v.
If all that checks out, the pcb in the bottom is probably faulty.
Penguin45.
