Forum Replies Created
-
AuthorPosts
-
Penguin45
ParticipantRe: Football season 09/10
My nerves are shot…..
Chris.
Penguin45
ParticipantRe: Football season 09/10
Watching on cable – pic OK.
Leeds just got out of their half…
C.
Penguin45
ParticipantRe: Football season 09/10
Good grief – 10 mins in – Tottenham inspired, Leeds keeper inspired, penalty missed – it’s going to one of those games……
Chris.
Penguin45
ParticipantRe: AEG FAVORIT 86070 VI – Leak behind side reservoir
Well done – new one on me!
Penguin45.
Penguin45
ParticipantRe: Diplomat ADP 8112 Thermostat
The safety thermostat is doing it’s job. The machine is probably underfilling. There are three black hoses running side to side across the bottom of the machine and they fill up with sludge. You will need to remove the water matrix from the left hand side of the machine fopr full access.
Clean out hoses and the spigots which they fit to and it’ll *probably* be fine.
Power off first, of course.
Penguin45.
Penguin45
ParticipantRe: wrong part?
4812 360 68687
Chris.
January 23, 2010 at 2:02 am in reply to: repair combine grill/oven element for built in Arrow help #309658Penguin45
ParticipantRe: repair combine grill/oven element for built in Arrow hel
Hello.
The element required will be in amongst this group HERE.
Please note that THE FORUM RULES are quite specific – we will not take you through the job screw by screw, wire by wire.
Note that Arrow as a brand is dead, the manufacturer who supplied Arrow has also gone bust – long term, you’re on a hiding to nothing.
If you feel that you have to try and get it going, the top and bottom elements are retained by screws from the rear, so removing the rear cover is your access point. The fan oven element is behind the panel in the back of the oven (Four screws from memory), although I think it is screwed from the rear.
Make diagrams before removing any wire or fitting and isolate from the supply before touching anything.
Penguin45,
Moderator,Penguin45
ParticipantRe: Zanussi zdf 501s
.20 is time out on drain – it still thinks it’s full of water. You either definitely do have a blockage somewhere, or the level switch is malfunctioning (unusual).
Penguin45.
Penguin45
ParticipantRe: The cleaning problems continue – Bosch
If the machine is stopped during circulation, the standing water should be at least at the bottom of the salt cap and better still, half way up it.
Penguin45.
Penguin45
ParticipantRe: Indisit WIA121 Motor connector block
Been on Connect again, Mike? There are some real world prices out there.
Chris.
Penguin45
ParticipantRe: Aquarius wt540
You are wise, Master Helo…. 😀
:p45:Penguin45
ParticipantRe: Aquarius wt540
Start switches fall off the pcb with surprising regularity….
Penguin45.
Penguin45
ParticipantRe: John Lewis JLWD 1609 E20 error on drying
Broken wiring to the temperature sensor in the hose connecting the condenser to the tub will cause this problem.
Penguin45.
Penguin45
ParticipantRe: ignis door hinges
4812 417 19339 – hinge
4812 417 19137 – hinge runnerShowing as s/o from Masterpart.
Chris.
-
AuthorPosts
