Forum Replies Created
-
Posts
-
Re: Diamond H electric thermostat wiring
If A+B were a make-and-break switch and F+G is a make-and-break switch (Check contacting with your test meter), polarity won’t matter as it’s an AC circuit.
I can find nothing relating to a 1200G cooker – check model number or better still find the pNc number.
Penguin45.
Re: hotpoint WF 220 bearing
Big fun – not.
Front off, tub out and spilt, measure shaft at front bearing.
If it’s 35mm, you can buy a BEARING AND SEAL KIT and if needed, a DRUM SUPPORT.
If the shaft is 30mm, you can get a BEARING AND SEAL KIT. However, if the shaft shows the slightest signs of damage, you need to replace it and it isn’t a spare part. You’ll need to buy a TUB REAR HALF and a 35MM DRUM SUPPORT.
Apart from that, it’s out with the sledge hammer and drift.
Penguin45.
Re: Retro Creda Spindryer – looking for rubber outlet
Might be worth a word with http://www.automaticwasher.org/ . Restorers and fans of old laundry equipment…
The site itself is fascinating.
Penguin45.
Re: Hotpoint Aqualtis AQXXF149PM
It may be a fancy box, but it’s still an Indesit in a dress. PCB far and away the most likely candidate fro failure.
Have sent you some bedtime reading.
Chris.
Re: Kenwood kdw12sl3a
Well, it’s Chinese tat is the basic problem. Build quality is appallingly poor. Spending a tenner on a capacitor is fair enough; I wouldn’t be shelling out £90 + VAT + labour on it as you will then feel the need to repair it again next time it fails. And – it will.
Penguin45.
Re: Whirlpool ADP5966 Dishwasher with Rinse Aid Drink Proble
4812 466 68497 is the sealing gasket for the rinse aid cover. spares@ukwhitegoods.co.uk will be able to get you one promptly if you wish.
Penguin45.
