Forum Replies Created
-
Posts
-
Re: ariston afa350x
Fill not detected in the time allowed – flow meter is possibly at fault as there is some water fill; check for low water pressure as well.
Penguin45.
Re: whirlpool adp 4501/5 – 3 flashes error code
No heat in the time allowed. Dead heater or burnt-out wiring at the heater are both possible.
Power off if you intend to investigate this yourself.
Penguin45.
Re: Whirlpool DWF 406 flashes two times
There’s a leak into the tray under the machine. The water is operating the flood protection system (A polystyrene float and microswitch mechanism). Power off, drain the tray and try again. Leave the front lower cover panel off to observe if there is a leak.
Penguin45.
Re: New oven recommendations
Don’s the expert – he’ll be along in the morning with some informed advice.
Family forum, BTW – mind the language, please.
Penguin45,
Moderator.Re: Rinse aid compartment leaking (Whirlpool ADP6746)
Assuming that it’s just the gasket on the cover, you want p/no 4812 466 68495. spares@ukwhitegoods.co.uk will be able to get you one promptly.
If you take more than two minutes to fit it, you’re doing something horribly wrong!
Penguin45.
Re: Siemens Fridge Hinge problem
You can get spares HERE.
You will need the full and correct eNr number.
Penguin45.
Re: Fisher Paykel GW709AU Washing Machine Problem
Moved you down to the Oz forum, Mangoe.
There’s a sticky at the top of this forum with the diagnostics info in it – give it a go and see what you get.
Initial thought would be a hot water valve problem.
Penguin45.
Re: Spam
Westoncase – “enhancement” post put up and deleted. First one I’ve seen on an “@Yahoo” address….
Chris.
Re: AW23, PO5.
Programme 5, rather than the running time for 30/40 Mix. As you know, re-set clears it.
Chris.
Re: Manual for Prima oven ?
It’s a Magnet brand name, so contacting them is probably your best bet.
LINK.
In the meantime, THIS ARTICLE should offer you some pointers.
Pengiuin45.
Re: Servis Tumble Dryer not heating….
That’s not the model number – should be M2—-.
Commonest reason for no heat is the safety tripping on the heater thermostat. Press the red button, then find out why – restricted air-flow is the commonest cause. Crushed/blocked vent hose is a simple startting point.
Power off if you intend to resolve this yourself,
Penguin45.
