Forum Replies Created
-
Posts
-
Re: indeit oldie, 1069w
The vari-stat starts and stops the timer at the heat position – it does not turn the heater on and off.
Chris.
Re: CDA CI520 Tumble Dryer
013364 – belt
15660 – front feltSiltal machine – belt is in stock at Masterpart, felt s/o.
Chris.
Re: Baumatic BDW13
If it fills, stops filling and puts the heater on, the pressure system is working, surely?
Sounds more like a circulation issue.
Chris.
Re: Ariston A1637 (LB2000TRF) Error Flash – What does it mea
Motor problems. Check wiring for continuity and breakages. Check continuity through motor. Being an Indesit-based machine the problem is probably the pcb.
Be warned – this machine uses a high speed three phase induction motor. As a consequence, the capacitors on the pcb may store a charge of up to 500v for a period of ten minutes after programme completion.
Pulling the plug is not enough – you have to wait.
Penguin45.
Re: Diplomat ADP8102 leaking from door
Perished bottom door seal or a large build-up of crud? Door outer panel off to see properly.
Penguin45.
Re: How do I remove Bosch HydroSensor side panel?
Lid is retained by two spring latches at the rear. Lift each in turn while forcing the lid to the rear.
Side panels are retained by two screws in the front edge.
Penguin45.
Re: whirlpool g2p gwi dishwasher – light flashing 3 times
If you have a similar resistance reading when you meter the heater through the cabling from the pcb end, the only component left is the pcb.
Stick up the 12nc number (The one that starts with 8 ) and we should be able to identify it for you.
Penguin45.
Re: ignis adl 347 dishwasher problem
Ignore the beeps – count the pattern of the flashing start light; ie 1-2-3-4-pause-repeat.
Penguin45.
