Forum Replies Created
-
Posts
-
Re: BWD129P with 3phase motor
Came from EMW and as stated does the whole cycle but hangs after first rinse with lights stated above flashing
Re: Configuring Zanussi module
Hi Guys,
I’m after entering the coding sequence for Hexidecimal programming for the ZJ1217 which doesn’t have the Digital display. The last one I carried out was some years ago and can’t remember it. Help would be appreciated. ThanksChris
Re: DRCS68 Tech Info anyone Please
Mmmm….I’ve done it again, thanks… any help though 🙂 Appliance is a Beko.
Re: HNWL6136 Tech info and wiring information please!!
Yes Martin, I’ve got that far, I’m on a washer dryer that will only go as far as the first stage fill. Diagnostic is going through fine so I’m flummoxed 🙁 pressure switch checks out ok
Re: WMA50P
You are a star, sorry I never twigged it was a link, obvious now though! Thanks again for your always prompt responses
Re: WMA50P
I’m thinking I’ve put a connection on wrong to the user board as it’s filling and going through the program ok until rinses. I’ve checked everything else, heater etc and it was pumping when I first put it on to confirm the fault that the customer reported. Scoring on all the tracks confused the reassembly once the board was repaired. Simple job but there is more than one place that two of the connections can go. I don’t want to blow the board so relevant info would be a great help. The Ultima info is diagnostics and not relevant.
Re: WMA50P
If you could Jim, I’ve had Ultima Vogue 2 Digital diagnostics but nothing relating to the rotary control board.
Re: SMEG DUCO4SS Any Tech Info please
Ok! My guess is of course the tangential fan TOC’s are suppose to be open circuit. Wiring for top oven/grill is ambiguous!
Re: Leisure HJA6100 Diagnostics and any other Info Please
Ok, changed Sensor in Fridge, everything doing as it should in diagnostics. However, when attempting to adjust the fill level on the Ice cube tray it won’t let me. ‘Ice off,’ hold selection for 5seconds while in normal operation…..nothing, not a sausage!!! No Parameters displayed, just carries on as if nothing selected…oh dear!! Customer got this new and it’s been locked in his garage for 2 years while his house was being renovated. Epic Fail!!! New board?
