Forum Replies Created
-
AuthorPosts
-
RickT
ParticipantRe: Neff B15E54N0GB/01 oven no heat
Hi Martin, No key, just the time display.
RickT
ParticipantRe: Qualtex Account Closure
Same here. Letter received yesterday. Always paid my account on time. Admittedly I haven’t been ordering as often, since the higher free postage threshold introduced. They also seem to be basing their prices on Connect’s. They initially approached me for business only to up their limits a few months later. These companies want it both ways. They supply trade as well as retail and expect there order rate to remain constant.
Their loss.RickT
ParticipantRe: Bosch WAK24260GB Fault codes
Sorry, just revised model number. WAK24260GB
RickT
ParticipantRe: stoves 900gdo
Open door. Remove inner glass. There should be a hole on each hinge insert where you can insert something like a drill bit. Remove left and right screw halfway down the door. The door should now pull off. From memory, the hinge is secured from the side. Once the screw is removed, the hinge assembly should just slide out.
RickT
ParticipantRe: Aeg f34502v10 91153911400
Could the mod kit be 4055346060. Food debris blocking the sensor is the usual culprit though.
RickT
ParticipantRe: Bosch dishwasher S41E50N0gb Noisy wash
Thanks for the help.
The noise is apparently fairly constant once it starts. Customer put his phone up to it and the noise did sound constant and LOUD. I’ll re-visit and disconnect the divertor motor and see what occurs.RickT
ParticipantRe: Bosch WIS24140GB fault codes
Replacing analogue pressure switch sorted it.
RickT
ParticipantRe: Lamona oven error 22????
Just found info on their microwaves and error 22 points to thermistor sensor fault. So I’m guessing they’ll have the same code system for the ovens.
RickT
ParticipantRe: John Lewis E52?
Hi Jim, Are the wires inside motor plug ok? NTC or connections?
RickT
ParticipantRe: Wanted AEG motor.
Hi Gary,
If the bearings are seized,these can be stripped down and replaced.RickT
ParticipantRe: Bosch WVF2402GB/02 Washer/Dryer No Wash/Agitation…
Hi, Does the timer move through the spin cycle. Possible timer motor o/c and timer stuck between forward and reverse actions.
Hope this helpsRickT
ParticipantRe: AEG Oven BP3003001M
Returned to oven. Checked output of the two suspect 35volt capacitors. I charged with 30 volts and both held the charge for a good 10 minutes. Stumped by this, I just replaced the 220uf cap as I had one handy. Re-connect power board and bingo, timer springs into life. So, a bit of a mystery. Customer has been using oven for 2-3 days and all is well. 😀
RickT
ParticipantRe: AEG Oven BP3003001M
Thanks for the info Dave. I’m going back tomorrow to double check. As I say I removed all of the capacitors and tested the farad readings and all ok. Didn’t check the output though.
RickT
ParticipantRe: AEG Oven BP3003001M
Thanks Dave. I’ve checked through the service manual on Connect site. I already meggered the oven and cooling fan motors, elements, temp sensor and tested the light circuit. All fine. This oven doesn’t have the steam feature.
PNC 94418576501.Cheers Rick
RickT
ParticipantRe: Neff double oven U1661N0GB/02 fault codes
I’ll give that a try. Many thanks
-
AuthorPosts
