Forum Replies Created
-
Posts
-
Re: Wma54 hotpoint washing machine
ah so the leds on are not or may not be the error? ok i’m speeding up now…. So into diagnostics and read the error from there! yes it was a late nite last nite! 😉
Thank you for your kind help sir. 🙂Re: Wma54 hotpoint washing machine
Cant seem to find the sequence i have. I did look this up. If its here i must be slow!!
Re: Spares for 857586815010
Thanks Don, I see a link for the new ISE1607w who would i chat to about this brand?
Re: Whirpool ADG7550 not draining-changed the pressure switc
Might need to check the connection block for bad contact on the diaphram switch. Have heard a few Whirlpool guys changing the block for spade connectors…! Maybe…
Re: Hoover HC6150m
This customer bought a new unit and i brought this one home where it has gathered dust…. til now!! just put a new tacho into it. No joy same issue! to be honest i should walk away and scrap it but it’s bugging me!!! could this be the pcb? anyone worked on this model with same issue?
Re: whrilpool american style F/F 858615815000
sorry about the delay in reply. the serial number is 110428007984. The 12nc is as posted on the Subject. Appreciate the help.
Re: Electrolux FF ENN26800
Have you checked the evaporator at the top of the freezer?? If this is choked up with white ice then this will prevent the air circulating up to the fridge compartment. This can be caused by 1. faulty heater 2. Faulty sensor at the rear of the evaporator. The evaporator drops down with a bit of manouvering. Hope this helps.
Re: IWDC6105 Indesit washer dryer
Had to leave flat before I could do full diagnosis due to the customer being a bit loopy!! So thought I’d run it by you guys. I would be 80{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure it was a faulty valve myself. Thanks for the swift reply.
Re: Candy GO482/1-80 washing machine
Do the drums in these units have alot of play on the shaft. I can move the drum up and down about 10mm approx.If the blocks were loose, would prolonged use damage the inner bearing?.
Re: SWD80p hotpoint dishwasher
Yep it has rust marks on the base and even up to the wash motor… could be an earth leakage from there?? If I unplug the wash motor that should answer that question??
