Simon46

Forum Replies Created

Viewing 15 posts - 271 through 285 (of 2,216 total)
1 2 3 … 18 19 20 … 146 147 148
  • Author
    Posts
  • August 20, 2013 at 10:58 pm in reply to: Stoves Double Oven EFa 700H #399342
    Simon46
    Participant

    Re: Stoves Double Oven EFa 700H

    No worries.
    S.

    August 16, 2013 at 6:07 pm in reply to: Stoves Double Oven EFa 700H #399339
    Simon46
    Participant

    Re: Stoves Double Oven EFa 700H

    Does it have a resistor in line? If so you need to test with meter as shorted fan may have blown it.
    S.

    August 13, 2013 at 5:28 am in reply to: Stoves Double Oven EFa 700H #399336
    Simon46
    Participant

    Re: Stoves Double Oven EFa 700H

    COOLING fan (seperate) behind oven should run after switch off. Controlled by pcb.

    S.

    August 12, 2013 at 1:40 pm in reply to: Hotpoint dishwasher. #398911
    Simon46
    Participant

    Re: Hotpoint dishwasher.

    Seem to have done the same to a bosch dishwasher diaphragm cleaning the crud out of it once!

    August 10, 2013 at 10:31 pm in reply to: Hotpoint dishwasher. #398909
    Simon46
    Participant

    Re: Hotpoint dishwasher.

    Is the circ pump running or humming ie 240 to it?

    S.

    August 10, 2013 at 1:18 pm in reply to: Beko Leisure HJA6100 Fridge Freezer #398913
    Simon46
    Participant

    Re: Beko Leisure HJA6100 Fridge Freezer

    You may need to unplug fridge freezer and do a 12 hr door open defrost. Rear panel may have frozen to evaporator.

    .

    August 10, 2013 at 1:11 pm in reply to: Bosch Model No SD13GT1B #398900
    Simon46
    Participant

    Re: Bosch Model No SD13GT1B

    Or bosch part no 00600233

    S.

    August 9, 2013 at 11:10 pm in reply to: Bosch SGS45C02GB problem #398880
    Simon46
    Participant

    Re: Bosch SGS45C02GB problem

    Drain pump jammed with glass etc usually.

    S.

    August 9, 2013 at 11:08 pm in reply to: Bosch Model No SD13GT1B #398895
    Simon46
    Participant

    Re: Bosch Model No SD13GT1B

    Mains suppressor leaking to earth usually. Disconnect from mains if you are going in.


    S.

    August 9, 2013 at 6:03 am in reply to: New Candy CIC60 timer #398849
    Simon46
    Participant

    Re: New Candy CIC60 timer

    Can you see the numbers on the terminals on the new timer to correspond to the old nos. No diagram im afraid.

    August 8, 2013 at 4:03 pm in reply to: New Candy CIC60 timer #398847
    Simon46
    Participant

    Re: New Candy CIC60 timer

    What is hoover candy part no of the one you received?

    August 7, 2013 at 4:24 pm in reply to: Timer problem Indesit WG1234T Eaton 4684.01D #398772
    Simon46
    Participant

    Re: Timer problem Indesit WG1234T Eaton 4684.01D

    Iirc hot fill may only come on 60 or 90 degree wash. Did you try it on those before?
    S.

    August 7, 2013 at 11:51 am in reply to: Hotpoint DC27 Wash light flashing #398816
    Simon46
    Participant

    Re: Hotpoint DC27 Wash light flashing

    The solenoid valve is not working. Is it filling?
    Unplug power if you are going in.

    S.

    August 7, 2013 at 11:08 am in reply to: whirlpool apm 6002 fridge not cooling #398802
    Simon46
    Participant

    Re: whirlpool apm 6002 fridge not cooling

    Water droplets on back wall with compressor running? Might run for APPROXIMATELY 30 mins then stop till back wall defrosted.

    .

    August 7, 2013 at 7:36 am in reply to: whirlpool apm 6002 fridge not cooling #398800
    Simon46
    Participant

    Re: whirlpool apm 6002 fridge not cooling

    Does the compressor run continuously and ice on back wall of fridge? If so unlikely to be thermostat unless it switches off compressor. Are INTERNAL doors closing ok?
    S.

  • Author
    Posts
Viewing 15 posts - 271 through 285 (of 2,216 total)
1 2 3 … 18 19 20 … 146 147 148