Forum Replies Created
-
Posts
-
Re: Hotpoint bwm129 built in door seal
Cable tie and pliers.
post374746.html?hilit=pliers#p374746Qualtex do a set of 45 degree QUAMIS205 but I have borrowed a set from b@ q before and returned undamaged 😯 😯
Re: How to change brushes on Bosch Logixx 8 ?
If the brushes have bedded in now no reason to upset it again.
Flat brush end is now curved to shape of commutator and will have cleaned the segments to shiny copper.
S.Re: Hotpoint VTD00p motor wont turn
Unless wiring to start capacitor had broken intenally at capacitor end. if ok new motor required.
Re: Hotpoint VTD00p motor wont turn
Does the drum turn by hand ok if you open the door? Unlikely to be faulty spare. If cap fitted correctly then motor start windings gone.
Power off if you’re going in.
Regards
S.Re: Bosch Classixx 1200 Express – decent secondhand buy?
Good buy. I’d have one. In fact I’ve got the same model but with display.
S.Re: Bosch Classixx 1200 Express – decent secondhand buy?
Post enr no from inside door here.
Regards SimonRe: Fagor fwd612it: Dryer fault
Wait 15.
post292006.html?hilit=fagor#p292006Re: Hotpoint WMUD962 – no fill
Would it be possible then with this fault when testing it the heater may come on with no water in the drum? Just a thought to test it on rinse instead of wash.
S.
Re: cda smeg cw448 lower spray arm
Ok replaced arm still water running down door. Then error code appeared (antiflood)Turns out the rubber hose had slipped down off the lower spray arm duct support in the base and was spraying down decor door. New support has ribs to hold pipe on with Corbin clip. Fitted jubilee clip instead as it started to slip again under wash pressure.
Sorted
S.Re: Hotpoint FF4DK main PCB needs programming please
You need to buy a card reader and card to download into the unprogrammed pcb.
Regards
SimonRe: IWDE126 F5
Is the machine full of water? The pressure switch reads the water level. When empty does the pump impellor turn if machine set to drain by removing filter and looking in. Might be another coin in hose if turning ok. Unplug power if you’re going in!
Regards
SimonRe: Advice needed – Safety Issue!
Been to one fdw20 today up in smoke. Lady was leaving the building when she smelt burning!
http://s235.photobucket.com/user/Simon4 … sort=3&o=0http://s235.photobucket.com/user/Simon4 … sort=3&o=1
http://s235.photobucket.com/user/Simon4 … sort=3&o=3Feel free to put it in another post if this is the wrong place
Regards
Simon
