Forum Replies Created
-
AuthorPosts
-
Simon46
ParticipantRe: Smeg SE335SS-5 Oven Fan Not Working
The switched feed will be from the selector switch on front panel. You need to find the wire going to theother side of the motor. It will need a live and neutral to work. A multimeter will tell you which one it is. Power off if you are tracing wire.
S.
December 18, 2008 at 9:06 am in reply to: Integrated appliances – Are we human or are we joiners #271455Simon46
ParticipantRe: Integrated appliances – Are we human or are we joiners
Did one yesterday 4h15 mins. Deinstall from tiled up to plinth, raised floor to tile level with wood on curved floor and fitted new bosch only to find the waste plumbing 90 degree elbow behind a cupboard in a corner had a kinked push fit o ring from when the kitchen was installed. Was leaking onto floor and ring main. All out again. dismantled cupboards to fit 2 quid compression elbow and reinstall. A pig of a job but with wet rot on boards and wet electrics concerned cust was quite happy to pay for the time. 😀
S.
Simon46
ParticipantRe: Zanussi TDS382W dryer. How many bearing pads?
Many thanks Geoff. It is of great help.
S.
December 16, 2008 at 11:30 pm in reply to: Lec Elan mdl EL654AW stooped working how do I remove casing? #271676Simon46
ParticipantRe: Lec Elan mdl EL654AW stooped working how do I remove cas
environment then.
S.
December 16, 2008 at 12:37 am in reply to: Lec Elan mdl EL654AW stooped working how do I remove casing? #271673Simon46
ParticipantRe: Lec Elan mdl EL654AW stooped working how do I remove cas
If your garage is too cold it wont come on. Put some hot water in a bowl place in fridge and seee if it kicks in.
S.
December 13, 2008 at 7:28 pm in reply to: hotpoint first edition (few10) door lock need help plz #271510Simon46
ParticipantRe: hotpoint first edition (few10) door lock need help plz
was the original red and the new white? if so the plug requires turning the other way round. Unplug before checking.
S.
Simon46
ParticipantRe: Hotpoint Flashing Lights
How low is the drain pipe end?
S.
Simon46
ParticipantRe: Diplomat APM6855 F/Freezer fan motor
Not reading open circuit is it? The one i had worked but no reading across terminals.
http://www.ukwhitegoods.co.uk/modules.p … ht=apm6855S.
Simon46
ParticipantRe: Internet in the van
I have mobile phone with them. So they half price the monthly charge of mobile internet (18 month). Offsets the £90 quid battery i have to buy for easynote laptop and the 19V 6amp in car charger for 30 quid from maplins 😆 .
December 13, 2008 at 10:38 am in reply to: Integrated appliances – Are we human or are we joiners #271448Simon46
ParticipantRe: Integrated appliances – Are we human or are we joiners
Do all the manufacturers do this when the appliance is under warranty?
S.
Simon46
ParticipantRe: Candy sprint 120 timer clicking round.
Many thanks Micky.
Simon (posting from the van 😀 )
Simon46
ParticipantRe: Hotpoint fridge freezer FF68
Warning light for high freezer temp?
S.
Simon46
ParticipantRe: Whirlpool ADG7540/1 Not Heating Water
That does not sound right. I assume meter is ok.
S.
December 11, 2008 at 1:40 pm in reply to: Tricity Bendix Dishwasher DH 090 faul (is this motor related #271229Simon46
ParticipantRe: Tricity Bendix Dishwasher DH 090 faul (is this motor rel
Horseshoe hose underneath?
S.
Simon46
ParticipantRe: Baumatic bdw14 hinge straps/cords
Do you have the part number for springs?
S.
-
AuthorPosts
