Forum Replies Created
-
Posts
-
Re: Bosch error code
just checking out on bsh web site. what does sensor part no. 031733 do (situated on left near salad box)? I take it the sensor thats faulty and causing the E2 error is separate and buried in the bowels of the fridge(?)…
Re: Belling 6060 slow reaching temp.
thanks for that gents. Pilot staying on for 45 mins. Will try element first. Strange that both fan ovens are behaving like this.
Re: Candy W/D bizarre no fill fault.
Hi Martin, I have sent you a private message with my email for the info you were kindly going to forward. Thanks, Simon.
Re: Candy W/D bizarre no fill fault.
Picking up my old thread here…
The customer NOW informs that it does start flashing eventually.
The active rinse light and the 90 min. light adjacent both flash 3 times and then pause. Candy model again, CMD146-80.
Does anyone have fault codes please? Thanks. Simon.Re: Candy W/D bizarre no fill fault.
Thanks Gents, dont think blocked pressure system cos its only 13 mths old and it seems to fill ok on rinse. Fault also seems to be consistent.
Will double check heater and brushes….Re: Candy W/D bizarre no fill fault.
Thanks Martin. No, it seems to trundle on through as if everything was fine. I obviously havent watched a FULL cycle, but customer says it goes on through to the rinse cycle, which then fills as normal.
Re: Bosch Dishwasher SGS43T52GB/16
does have a flow meter, part no. 424099 which seem to go fairly often.
Re: AEG condenser dodgy countdown
😀 Thanks very much for that, sorry to be slow acknowledging. Will run test through and see what happens, Simon.
Re: Smeg DWI612C pumping when finished.
Thanks for that, I’ve heard of those solenoids doing strange things!
Will check that out.Re: Smeg DWI612C pumping when finished.
Adding some extra details… the pump runs in pulses (ie on for a sec, off for two, on for a sec. etc.) and bleeps as it pumps. Unable now to reset prog. Just locked on this intermittent pumping. No flashing LEDs to indicate a fault. (5 LEDs and a prog. select button.) Thanks in anticipation.. 😉
Re: Miele W698 no door release and no fill, etc.
Thanks for that. Have tried cleaning it up but on this occasion it doesn’t seem to be the problem… Will find that useful in future though. Simon. 😀
Re: Bosch WTL6304GB/02 umbrella damage!!!
Greg, much obliged for your help.
Have tested with a full damp load; have checked reset stat. Noticed a carbon stick by the back bearing and it was pretty gnarled from the earlier damage. Is that one involved in sensing or just anti static? The carbon on the top of the drum seemed fine. Simon.
