Forum Replies Created
-
Posts
-
Re: Bosch washing machine, stopping in the middle of the spi
This is getting a bit confusing.You say that 1-4 are in red.I assume that is because they are the hot wash programmes so it won’t go to 5 as that would be the start of the cold washes.5-8 in blue are the cold programmes.9-12 would be extra rinse spin programmes,denoted by symbols.
Re: BEKO WMA765s – Programs freeze
No real trick to it.They are tight and normally a little amount of force is required.Try using a large flat screwdriver and gently prise the motor loose.
Re: WIL123S Need Help
Putting a washing machine on it’s side is always a bad move.The chances are that water has got into the electronics.
You can take the top off and check that none of the wires have come loose,but I have the feeling that water has got on to the circuit board.
disconnect from the mains before taking lid off.Re: BEKO WM5102W Auto Washing Machine lights on but not work
Ok,back to basics.If the door is closing correctly, the time delay is not activated or any child lock switched on.Check the water supply is on and that there is no kinking in the inlet pipe.If all these are correct contact the supplier as it is a new machine and will be covered by a warranty.
Re: BEKO WM5102W Auto Washing Machine lights on but not work
Is it fitted with a time delay facility?If so check this has not been activated accidentally.
Re: Cleaning a filter of Whiteline MT 1062 LED
That should come out with the black cap.There is something in the filter that will not allow it to be removed.You can try to GENTLY prise it out.
Failing that you will have to remove the pump.Power off first.Re: Indesit WIDXL146 module
The new module needs to be programmed to your machine.When you ordered did you confirm it was pre programmed?
Re: Hotpoint WMA63 will not spin or turn under power
Hi,sounds like the brushes.
Unlikely that cutting the power to a machine that is not running will cause any damage.Re: LG F1447TD5 DirectDrive 8kg – mildew/water in draw outfl
Hi,no that pipe should not have “standing water”it’s blocked.
2 options,either clean the pipe in situ or
Unplug, take off top and disconnect the pipe and clean throughly.
SteveRe: Hotpoint WMA32
Whenever I have had to configure a new board I use the instructions that come with it.
Re: Hotpoint Aqualtis AQGMD149 – F5 Machine is Blocked
Trace the wire that is still connected.It will lead you to where the loose wire should be connected as they both go to the same component.
It sounds like the wire has broken and will need repair or replacement.
Forum rules prohibit the posting of wiring diagrams.Sorry.
Don’t forget keep machine unplugged when working on it.
SteveRe: Indesit washing machine not turning – Motor or Module?
Nope,I mean the mains capacitor,sometimes called the mains filter/suppressor.
Normally white in colour and cylindrical shaped,with electrical terminals on top.
