TeeMyob

Forum Replies Created

Viewing 15 posts - 121 through 135 (of 204 total)
  • Author
    Posts
  • in reply to: LG WM1433 Washing Machine Module #335965
    TeeMyob
    Participant

    Re: LG WM1433 Washing Machine Module

    Thanks for that, as I assumed.

    Just thinking the motor could be faulty then?

    TM

    in reply to: LG WM1433 Washing Machine Module #335963
    TeeMyob
    Participant

    Re: LG WM1433 Washing Machine Module

    I often repair boards but may just had this one back to LG.

    Was wondering why this capacitor should blow (end popped off with a bang).

    What does this capacitor do?

    TM

    in reply to: LG WM1433 Washing Machine Module #335962
    TeeMyob
    Participant

    Re: LG WM1433 Washing Machine Module

    I just replied to this post and it got lost!

    TM

    in reply to: LG WM1433 Washing Machine Module #335920
    TeeMyob
    Participant

    Re: LG WM1433 Washing Machine Module

    Thanks, looks like a tricky job. Often repair boards but might hand this one back to LG.

    Just wondered if something in particular is causing the problem!

    What is that Capacitor on the main board for? Anyone?

    TM

    in reply to: LG WM1433 Washing Machine Module #335960
    TeeMyob
    Participant

    Re: LG WM1433 Washing Machine Module

    I might have to try another module then!

    TM

    in reply to: Dyson Pay Up Front #327996
    TeeMyob
    Participant

    Re: Dyson Pay Up Front

    kladave wrote:Dyson

    Once you make a sale you register the machine via dysons website and they send you the remaining amount.

    Dave

    As if retailers don’t have enough admin!

    TM

    in reply to: Hotpoint vtd65 dryer module #335275
    TeeMyob
    Participant

    cut-out

    helo_75 wrote:cjheck the cut out on the heater 😉

    Hello,

    Thanks for that.

    Checked both cu-out.TOC’s

    TM

    in reply to: Indesit washing machine explodes #330640
    TeeMyob
    Participant

    Re: Indesit washing machine explodes

    Well, when you have all finished bashing the poor family with the washing machine…..

    What if it had been a Miele in some leafy suburb, wife of Screw & Hugh Solicitors. Maybe have settled out of court for a new Multi thousand pound kitchen and bling Range Rover for the wifey.

    TM

    in reply to: Samsung RS21 American F/F fridge not cooling #335067
    TeeMyob
    Participant

    Re: Samsung RS21 American F/F fridge not cooling

    I did send you a PM!

    in reply to: Hotpoint vtd65 dryer module #335273
    TeeMyob
    Participant

    Re: Hotpoint vtd65 dryer module

    Having inspected the New module inside the plastic housing, there is black around some of the components.

    In addition the date on the new board is only a few weeks later than that of the one fitted from production!

    TM

    in reply to: FAGOR FU-6146IT #335126
    TeeMyob
    Participant

    Re: FAGOR FU-6146IT

    loopey wrote:F01 Appliance has failed to fill
    F02 Appliance has failed to drain
    F03 Appliance has detected drum imbalance
    F04 Door lock has failed to engage
    F05 Temperature Sensor outside expected range
    F06 Appliance has failed to heat
    F07 Overflow Detected/Blocked Drain Pump
    F08 Motor has failed to operate
    FO9 Drum not turning

    Thanks,

    A “THANKS” button on the forum would be good!

    TM

    in reply to: Samsung TS48WLUS1/XEU American Fridge Freezer #335065
    TeeMyob
    Participant

    Re: Samsung TS48WLUS1/XEU American Fridge Freezer

    r600a wrote:Hi

    As i said.the fault is for a external connection comunication port.As soon as i seen the picture i remembered the model and have seen 2 of them i =n the past 5 years.Who i samsung tech did you speak to as its in the manual.

    Also if your main board isnt comunicating with the door control panel it may reading the manual throw up this error (i think).difficult to understand a bit as they call it differently.

    Check all the connections from the top of the door right down to the connections behind the door control panel for continuity seperatly.

    It is the 1st figure 8 from left freezer side ?.

    Bryan

    Yes Bryan

    [8][8][8][8]
    ^
    ^
    This One

    Lower Left Vertical flashes changing 8 to 9

    I will have to make another appointment to check all the connections again.

    The fault is not in my Manual but my manual is about 10 years old!

    Thanks for all your help Bryan, very much appreciated.

    TM

    in reply to: Samsung TS48WLUS1/XEU American Fridge Freezer #335063
    TeeMyob
    Participant

    Re: Samsung TS48WLUS1/XEU American Fridge Freezer

    Thanks Bryan,

    The Model is an Import Special, only available from Bradshaws in the UK. Price is a whopping £7,000.00

    As far as I am aware, it has no internet connection.

    I have replaced the main board as a trial as Samsung Tech cannot pinpoint the fault code. However, it still fails to operate.

    At a bit of a loss as to what to try next.

    The machine belongs to a Premiership football player who is moving out and wants it fixed ASAP.

    Comet attempted to fix it 3 times
    Another Engineer has tried and failed

    And now I have ended up with the call………….

    So far suggestions have ranged from…….

    Display PCB to Poor Earth.

    Anyone any further suggestions?

    TM

    in reply to: Samsung TS48WLUS1/XEU American Fridge Freezer #335061
    TeeMyob
    Participant

    Re: Samsung TS48WLUS1/XEU American Fridge Freezer

    Thanks R600, that would be great.

    TM

    in reply to: Lg Washing Machine Module PCB DEAD #333408
    TeeMyob
    Participant

    Re: Lg Washing Machine Module PCB DEAD

    I was thinking Motor!

    Have to go back tomorrow! (TODAY)

    TM

Viewing 15 posts - 121 through 135 (of 204 total)