Forum Replies Created
-
AuthorPosts
-
TeeMyob
ParticipantRe: Samsung fridge freezer SRL3616B led 5 flashing
Hello,
I have just answred this in another post.
Common fault is the geared motor not aligning with magnet.
I don’t have the samsung part number to hand but here is an example Connect 5045172161123.
This fault will usually result in 5 LED flash. I would also recomend you replace the yellow evaporator thermistor,
Let me know how you go on?
Hope this helps?
TM
TeeMyob
ParticipantRe: whirlpool american s20br5b21-ag
Do you know how to test the Ice maker module?
I suspect the Module is faulty.
Providing the obvious have been checked like
*Water turned on!
*Water tube from Valve is not brittle, leaking and tipping onto floor!Etc?
TM
TeeMyob
ParticipantRe: F02 error code on Fagor FU6146IT
THANKS folks
TeeMyob
ParticipantRe: liebherr fridge thermostat
Just tried it for you
Type “liebherr atea” into ebay
Ensure you tick worldwide box
Ensure you tick “include titles and description”It came up with a lot of Liebherr stats
You could also try a model search into http://www.ebay.de
TM
TeeMyob
ParticipantRe: liebherr fridge thermostat
Hello,
Liebherr (COOLETRIC) prices are a rip off. £5 stats for £80 simply beacuse they are model specific cut-in / outs OEM.
With Ranco Stats, I buy from German Ebay site. Last Liebherr stat was priced at £66+VAT from Cooletric – Bought OEM from Germany €22+Carriage (€6).
Try google/ebay search (include (check box) worldwide if looking on ebay))
Any help?
TM
TeeMyob
ParticipantRe: Candy FF
What model?
Fridge or freezer evap sensor?TM
TeeMyob
ParticipantRe: Samsung Rl36EBNS
Hello,
Common overlooked fault with these is the baffle geared motor cannot align.So the unit shuts down.
Don’t have the Samsung part no. to-hand but the connect code is 5045172161123.
If it is the deforst heater. Usually what happens is the appliance freezes and cools but when it enters an auto-defrost the appliances tays off until the yellow evap sensor reaches room temp.
Swithcing the appliance off at the mains for 15 secons will re-set the ROM on the main ECU/Module and the unit fires back into life.Hope this helps>?
TM
TeeMyob
ParticipantRe: SCHRIBER APM 6855 F/F
Yes a Common Problem
If the evap is full of Hoar Frost:
Disconnect the Power from Mains
Re-connect the Power
If the heater fails to heat up or the compressor kicks in
You can be 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure it is the Evap Sensor – Oddly Named “radiator probe” by ConnectBy the way, I think the:
Samsung Sensor DA32-00006W is the same resistance/voltage
You can splice a new Sensor into place. Make sure you solder/heat shrink or both.
TM
January 13, 2011 at 8:53 pm in reply to: Dishwasher CID60B10/ CDW60W10/ DW756FI (Haier I think) #340906TeeMyob
ParticipantRe: Dishwasher CID60B10/ CDW60W10/ DW756FI (Haier I think)
Thanks.
I totally agree re TAT
I guess there is no way of putting that to a Warranty customer!
Thanks very much for your reply.
TM
TeeMyob
ParticipantRe: LG DIRECT DRIVE MOTOR
canufixit wrote:5031680950151
sensor @ connect…… 1st choice……as to fault5031687978486
coil….@ connectThanks Canufixit
I have been looking for the sensor for ages on connect. Pity they don’t list it as “hall sensor”Thanks again
January 13, 2011 at 6:48 pm in reply to: Dishwasher CID60B10/ CDW60W10/ DW756FI (Haier I think) #340904TeeMyob
ParticipantRe: (Haier I think) Dishwasher CID60B10/ CDW60W10/ DW756FI
Are you all out repairing them too!
TeeMyob
ParticipantRe: LG error code CD
washdoctor wrote:The only codes from TD’s are:
EHE, ELE, bE, tE1, tE2, tE3, tE4 & dE… Must be one of those Whirl2?
Adrian.
Can someone tell me what EHE or ELE error codes are please?
TeeMyob
ParticipantRe: Samsung RS21WCNS (RS21WCNS1/XEU) Fuse Problem
R600a?
TM
TeeMyob
ParticipantRe: Samsung RS21WCNS (RS21WCNS1/XEU) Fuse Problem
compressor maybe?
I had cleared my van out and left my megga in the garage.
Will have to go back, just a bit in the sticks
TM
TeeMyob
ParticipantRe: Samsung RS21WCNS (RS21WCNS1/XEU) Fuse Problem
Fridge or freezer defrost heater R600a?
I know about the board fuse mod. But the fuse blows with nothing connected.
TM
-
AuthorPosts
