Washman

Forum Replies Created

Viewing 15 posts - 181 through 195 (of 894 total)
1 2 3 … 12 13 14 … 58 59 60
  • Author
    Posts
  • October 19, 2010 at 9:25 am in reply to: radio #333351
    Washman
    Participant

    Re: radio

    Hi


    My call is M3BIZ

    Mike

    October 18, 2010 at 5:25 pm in reply to: Rosieres 2040 grill problem in convection oven #333291
    Washman
    Participant

    Re: Rosieres 2040 grill problem in convection oven

    Hi

    For oven it uses both the lower element and the grill element,most conventional ovens do it that way. apart from ovens that have side elements.

    Washman

    October 4, 2010 at 11:49 am in reply to: Rangemaster classic 90 #331953
    Washman
    Participant

    Re: Rangemaster classic 90

    Hi

    Is the clock set to auto or manual. It needs to be set to manual for oven to work.

    Washman

    September 30, 2010 at 2:47 pm in reply to: Bosch SGS45A02GB/36 Leaking #326895
    Washman
    Participant

    Re: Bosch SGS45A02GB/36 Leaking

    Hi

    That part no on Bosch Eshop says “Auxiliary tool for threaded ring salt container”

    Mike

    September 19, 2010 at 4:36 pm in reply to: Are some Bosch and Siemens Fridge Freezers the same? #330896
    Washman
    Participant

    Re: Are some Bosch and Siemens Fridge Freezers the same?

    Hi

    Yes Bosch , Neff , Siemens all the same.

    Washman

    September 19, 2010 at 4:28 pm in reply to: AEG Favorit 5040 Water Level control query #330901
    Washman
    Participant

    Re: AEG Favorit 5040 Water Level control query

    Hi

    Wash pump needs to be running for correct water level,when wash pump starts water level drops so more water enters machine to fill to correct level.

    washman

    September 11, 2010 at 6:53 pm in reply to: Butler BWA 1719 – Help with fitting replacement belt! #330097
    Washman
    Participant

    Re: Butler BWA 1719 – Help with fitting replacement belt!

    Hi

    The new belt you have is wrong the 1183 part of the number is the length in millimetres, so the new belt needs to be 1194 the same as the old belt.

    Washman

    September 10, 2010 at 5:56 pm in reply to: Butler BWA 1719 – Help with fitting replacement belt! #330093
    Washman
    Participant

    Re: Butler BWA 1719 – Help with fitting replacement belt!

    Hi

    Just fit belt over motor pulley first then onto drum pulley and wind pulley around, be careful of your fingers.

    Washman

    September 10, 2010 at 5:50 pm in reply to: Britannia SI9S door hinge #330106
    Washman
    Participant

    Re: Britannia SI9S door hinge

    Hi

    Brittania 01253 471111 is the only place for spares.

    Mike

    September 8, 2010 at 5:49 pm in reply to: Resistance ready for flow sensor on whirlpool #329830
    Washman
    Participant

    Re: Resistance ready for flow sensor on whirlpool

    Hi

    The flow sensor is just a magnetic switch and a spinning turbine, the control pcb counts the impulses from the number of times the switch opens and closes. If switch fails and no impulses are detected machine goes into fault mode and gives you 7 flashes.
    Some times by unpluging the sensor connector and squeezing it to make a tighter fit of the plug on the sensor can cure this fault, other wise you have to buy the complete unit.
    Washman

    August 24, 2010 at 6:16 pm in reply to: Bosch Dishwasher SGS55C02GB/01 #328774
    Washman
    Participant

    Re: Bosch Dishwasher SGS55C02GB/01

    Hi

    The ribbed sump hose needs cleaning out. It goes from just below the red float across the front into the sump, just remove bottom front panels and hose just pulls out.

    Mike

    August 23, 2010 at 2:23 pm in reply to: Servis M9209 wiring diagram #328567
    Washman
    Participant

    Re: Servis M9209 wiring diagram

    Hi

    Forum rules

    8/ Please do not ask for wiring diagrams, schematics or for us to sort out any wiring problems over the internet. We cannot judge how competent you are nor the future readers of any thread, we’ll try to point you in the right direction but that’s as far as we can legally go.

    Washman

    August 18, 2010 at 5:31 pm in reply to: brittania range cooker #328162
    Washman
    Participant

    Re: brittania range cooker

    Hi

    Britannia Living Ltd.
    Britannia House,
    281 Bristol Avenue,
    Blackpool
    FY2 0JF

    enquiry@britannialiving.co.uk

    t. 01253 471111
    f. 01253 471136

    http://www.britannialiving.co.uk/

    That should be enough I hope

    August 13, 2010 at 8:06 am in reply to: samsung P1253 #327480
    Washman
    Participant

    Re: samsung P1253

    Hi

    Just remove filter and check, its most likely blocked .
    The user manual shows the filter.

    Washman

    August 12, 2010 at 1:13 pm in reply to: Intergrated Electrolux Washing Machine #327560
    Washman
    Participant

    Re: Intergrated Electrolux Washing Machine

    Hi

    Check dryer elements for earth fault or just disconnect dryer elements, and see what happens.
    Faulty elements can cause this.
    Mike

  • Author
    Posts
Viewing 15 posts - 181 through 195 (of 894 total)
1 2 3 … 12 13 14 … 58 59 60