[winker]

Re: Hoover HNF7138-80

Have I overstepped the mark,”duplicate deleted”Sorry I needed more help

steve

[winker]

Re: BAUMATIC MEGA 6SS WASHING MACHINE

thanks for that Kwatt

[winker]

Re: CREDA W220VW

WHAT A COMPLETE AND UTTER PLANK I AM.!!!!!

Did the version verification test…perfect,so I had programmed it correctly.

Checked the original pcb contacts and found the two black wires to the pressure switch were fitted to a position adjacent to where i had fitted them on the replacement.The original fault was a faulty lock which had obviously damaged something on the pcb (nothing physical)but after fitting lock door lock light still flashed.Changed the module,cure one fault and manufacture one of my own when i miss replaced a connector.

thanks for your help

[winker]

Re: CREDA W220VW

yes the fifteen stage corresponded as per the sheet.The problem i seem to have is on fill,it shoots a small amount of water in maybe a pint and then tumbles around.Some cycles top up after about 3 or 4 mins.

[winker]

Re: CREDA W220VW

Posted: Sun Apr 13, 2008 6:36 pm

——————————————————————————–
iadom wrote:
Module should be a 1604769 or a 1605332 for cold fill machines (after date code 41). After date code 29 they reverted back to an earlier version of software. The 1604769 is the replacement for all W220VW machines that are mixed fill.

E-mail sent.

Thanks for the info but considering my post,your info and your historic post above I am now still confused.The original board in the machine is referenced AKO 547 203.The version numbers 22 or 23 I assume refer to the software within the board ? Must get this sorted, your help is very much appreciated but still needed
New to UK Whitegoods? Click here to get a starter pack, all the stuff you need!

Earn more money through the UK Whitegoods monthly insurance, click to find out more

[winker]

Re: SIEMENS WD 61392 GB13

new ntc sensor all sorted cheers.The old one was o/c

[winker]

Re: SIEMENS WD 61392 GB13

Thanks for your speedy reply Martin

[winker]

Re: Bosch Dishwasher SGS43A18/GB27

ok I can check the coding but consider this,even if the code is wrong surely the dispenser would open allbeit at some given time during the cycle

[winker]

Re: Bosch module 489607

model Bosch SGS43A18 GB27

cheers steve

[winker]

Re: MATRIX RANGE COOKER

I need the oven selector switch.I would ideally need a thermostat,timer/manual switch,hinges and guides for the door.Any help appreciated

steve

[winker]

Re: HOTPOINT WASHER WF541

looks like F03 NTC,do you agree.What would the value of this be at room temp

[winker]

Re: HOTPOINT WASHER WF541

Good ole’ Hotpoint download a instruction book.

So the neons top to bottom are three and four which flash slowly and the on/off which flashes rapidly

[winker]

Re: HOTPOINT WASHER WF541

these run top to bottom 1-5,only identified functions not position…..plank

[winker]

Re: Hoover Dishwasher DT999

thankyou Martin

[winker]

Re: Hotpoint wm72 ultima

thankyou my friend

[Author]

Posts