[A1engineer]

Re: wf430p

Easy peasy straight swap common part

[A1engineer]

Re: Indesit washers on Watchdog

She got her door seal replaced for £35???

Did anyone notice the detergent was a gel type, this IMO is the real cause 😀

[A1engineer]

Re: hotpoint wma 42p drum seal issues

The seal should go side on if that makes any sense, you might find the plastic tank is warped tho…

[A1engineer]

Re: Hotpoint dryer water light Never comes on

Hi bob, thanks even after 10 min the light isn’t on, cust states it’s never been on, whilst I was there I used a wire to link switch wires had it on test for 20 min full heat it never cut off , pump ran and pumped water to bottle.

The light does come on when u switch on appliance as does all the others

[A1engineer]

Re: Hotpoint WDL 520P

probably a top pcb error, all lights flashing is usually a comms error between boards, check the idc cable at the top pcb if this looks ok id get a top pcb

[A1engineer]

Re: What do you carry?

insualtion, earth loop and multi meters

power scredriver, 7,8,10 nutrunners, 5.5,7,8,10,13 spanners and sockets
bent nose pliers, snips and pump pliers
crimping tool
few flat and philips screwdrivers
torque 15, torque 20 drivers and bits for drill
set of torque bits

a few other bits and bobs i really dont need but “just in case” 😆

also have a huge box in van full of various “just in case” tools
a gas tool kit
and a banging bag ( tools for doing bearings)

[A1engineer]

Re: wd640 module wiring

i think both go straight to the heater in which case it wouldnt matter

[A1engineer]

Re: Live testing

try not to do it but there are times when its needed

[A1engineer]

Re: Indesit WIXL146 Trips electric as soon as socket is swi

moulded plug, mains cable or suppressor 😉

[A1engineer]

Re: Belling or Beko Thermal fuse Belling BE335WH

4410101001 is the most recent one for most beko cookers they keep changing the part number :rolls:

very common on the d531’a etc complaint is usually back right ring and oven not working on inspeciton you discover no neons work.

HTH

Kev

[A1engineer]

Re: Hotpoint WF 860

did you change ntc as well??

id have a look at wiring especially around motor and concrete weght

[A1engineer]

Re: hotpoint bd32 cooker fan not working

stats are normal 1 is n/c 1 is n/o

sounds like a faulty selector switch to me

[A1engineer]

Re: Calling Old Timers..Hoover A2136 showing E1

E1 is a door interlock fault m8 😉

[A1engineer]

Re: beko d/w

pcb’s are bad on these, make sure you get serial etc as there are loads, i think they get stuck on prewash hense no heat!!

[A1engineer]

Re: Zanussi TC7102w

usually filters/condenser blocked, steam coming out door eventually causes stat to blow.

[Author]

Posts