Forum Replies Created
-
Posts
-
Re: Samsung RS21DCNS Hot on Metal Strip
Hi
The temperature your feeling is the refrigerant circulating round the system which is normal.To help reduce it check that you have air flow round the fridge freezer as these are not supposed to be built into units.Clean the condenser at the rear (large black coil) not compressor.
Bryan
Re: 1607w rubber lip thing around door
Hi Tony
Best to replace it especially if there is a run of limescale down below the door.
Bryan
Re: samsung fridge
Hi
This isn’t a drier. It’s a baffle and the unit will run quite happily without it. This was on the suction pipe normally just behind the compressor. Yrs hopefully you have changed the drier as this is good refrigeration practice.
Bryan
Re: Sept Meeting
Hi K
I do agree with Carl that we should put in no ticket no entry and tickets are sent out after registration so we can vet the requested ticket holders
Bryan
Re: Built in oven choice
Hi
if your looking for quality the the v zug wins hands down.The service is also provided by independents. Yes the company which was the distributor for the Uk pulled out but it has been relaunched into the UK by a new company over 18 months ago which has the technical back up with knowledge for over 20 yrs
The neff/bosch range is nowhere near the same quality as it was 20 years ago.
Bryan
Re: Built in oven choice
Hi
The ovens are top quality units.The steam oven keeps a lot of the moisture inside the food,The Back up is selective engineers across the UK.Where about in the country are you ?
Bryan
Re: Electrolux E0B 944 tripping out. More advice needed pls
Hi
Just a question..
Does the WHOLE oven cut off as in no power,no display or is it that the cooling fan stops or the element stops ?
Bryan
Re: Oven problem
http://shop.ukwhitegoods.co.uk/89966192 … an-control
Do you have one of these in your oven ?
Bryan
Re: Removed Thread
Hi Iadom
It was spam and not a actual bearing problem.I only deleted the post not thread.
Bryan
Re: Oven problem
I’ in the middle of no where at the moment with just my phone but I’m sure ken could find it for you.
Bryan
Re: Oven problem
Hi
There is a thermal cut out which has 2 white wires and 2 blue wires that are in a plastic tube normally on the left middle towards the front. This will have normally failed if the fan had previously gone. It senses the temprature and cut off if it gets too hot or thinks it has.
Bryan
Re: Seven Days A Week
eastlmark wrote:cannot believe any business in this trade does NOT work on Saturdays…. just a normal day for me for over 15 years and a good one for business, no school runs,less traffic on the roads, can charge more and a whole more relaxed feeling. Have a day off in the week instead.
Allways has astounded me that this trade is so reluctant to move a bit to fit in with our customers.Thats the way i used to see it…..but as i found out once i stoped
it changed nothing,£..on the money side,
and the area that i work in you dont get the quiet times in the week to have a day off,but i will work till 19.30hrs in the eve
for them ….so this i find works for me, but i would not like to be told to do weekends if i was employed… 😥Re: Seven Days A Week
jeremy wrote:7 days a week lmao. and when r people supposed to have a life then?
Sent from my GT-I9100 using Tapatalk 2
when your DEAD…….Thats the time for rest…….. 😉
weekend work will never be happening for me ever agin, gave it up
15 yrs ago never lost any turn over by giving it up,people that liked using me just wait till monday… 😀
canufixit
