Forum Replies Created
-
Posts
-
Re: Baumatic, no model number
Belt ajustment…?or poor load..
if it spins with out a load in it
then must be one of the above..!canufixit
Re: R600a electronic refrigerant scales
Hi Kez
ive got a couple of Vulcan scales spare..Never used them. Make me an offer by PM.
Bryan
Re: Unknown American Freezer
Hi
The appliance should be a Maytag. the plug should be at the back,maybe hidden behind the back cover.
Bryan
Re: samsung parts
Hi
Dependent on what parts,I can supply the most common cheaper than connect.
Bryan
Re: Samsung SR-S2026CVW Fridge Freezer – Ice build up in ‘fr
Hi
We can supply the repair kit that you will need.
E-mail me samsung@ffrservices.co.uk
BryanRe: Matsui MFI60 SN 002860 – PCB Issue
had one of these today with the same problem…
heater element gone to earth..replaced and all was well againRe: Domestic appliances – reliability and design
E-Mail sent concerning..Well guess Who..With back up e-mails .
Bryan
Re: Samsung SR-S2026CVW Side by Side Fridge/Freezer
I would but haven’t got a way to get it here..(luton)
Bryan
Re: Miele W828 rinse light flashing.
electrofix wrote:Canufixit wrote
i did not find the original fuse..put in some fuse wire 8amp
replacing an enclosed fuse with a piece of wire is not a good idea
its the same as putting a piece of wire across the fuse in a plugtopfirst of all if the fuse blows you will have molten copper over every component around
second an enclosed fuse blows quicker because it is not cooled by the surrounding air
third to make things worse you put a higher value than the originalthese fuses are easily available I think I got mine from Farnell so there is no excuse
Dave
dave
my fix is temp….its not staying like that it was to test
that it worked again….so fuse will be found before i move it on.
i will take a look for one on farnellall the best
canufixit
Re: Hoover HFA27K Fridge not cold enough
sensor at bottom right hand side of evaporator..release…reposition on top of evaporator..
No diagrams available…sorry..GIAS would deny any knowledge of problem
learnt by trial and error
Bryan
Re: Hoover HFA27K Fridge not cold enough
..Go on get me into trouble…
Common fault is that over a period of time ice builds up and blocks th evaporator… By moving the defrost sensor that would normally be on the bottom right of the evaporator and cable tying it to the very top centre.This will therefore allow a slightly longer defrost which would normally cure the problem.
Defrost the complete unit for 36hrs with the freezer door open before moving sensor.
Bryan
