admin

Forum Replies Created

Viewing 15 posts - 121 through 135 (of 12,518 total)
  • Author
    Posts
  • in reply to: Fixed Cost Repairs Are Dead #449277
    admin
    Keymaster

    Re: Fixed Cost Repairs Are Dead

    Hi I was just thinking about the very subject today. Is it about time the likes of repair care up the payments for the calls they send out. As it was stated earlier in the thread appliances are becoming increasingly complex to strip down and diagnose.

    And you think that’s gonna happen :rotfl: :rotfl:

    in reply to: Some Baumatic prices #450314
    admin
    Keymaster

    Re: Some Baumatic prices

    Mmmm

    I think someones been on the tipple overnight as the prices quoted are no where near the actual prices on the site.

    Bryan

    in reply to: HJA6740 Lamona larder fridge Auto defrost appears not to wor #450195
    admin
    Keymaster

    Re: HJA6740 Lamona larder fridge Auto defrost appears not to

    Hi. I have exactly the same problem. There was a build up of ice on the back of the fridge a couple of weeks ago. I removed it and today the red light was flashing and now the fridge has stopped refrigerating. Have you had any joy with yours?

    in reply to: Hotpot wmf740 #450196
    admin
    Keymaster

    Re: Hotpot wmf740

    please keep to one post for updates. dual post deleted.

    Bryan

    in reply to: ISE W1607W – pump trap jammed #450183
    admin
    Keymaster

    Re: ISE W1607W – pump trap jammed

    Hi Personally if it isn’t going to come out then your going to have to bite the bullet and either break the filter and replace the pump assembly. Or get an engineer out as lemon juice wouldn’t normally help. We have them in stock also.

    Regards

    Bryan

    in reply to: ISE W1607W – pump trap jammed #450181
    admin
    Keymaster

    Re: ISE W1607W – pump trap jammed

    Hi

    More likely you have got something trapped in the filter / filter housing.. You’ll just have to pull hard and twist at the same time to get it out

    Bryan

    in reply to: Ise10 1606W washer leaking underneath #449996
    admin
    Keymaster

    Re: Ise10 1606W washer leaking underneath

    HI

    Follow the water stains on the tank.

    Bryan

    in reply to: Samsung RS21DCNS #449940
    admin
    Keymaster

    Re: Samsung RS21DCNS

    HI

    Defrost heater, sensor,thermal fuse and evaperator cover will probably need replacing.

    Bryan

    in reply to: Minerva Services #448927
    admin
    Keymaster

    Re: Minerva Services

    No Comment !!

    Bryan

    in reply to: Hotpoint WMUD 10637 P (UK) Leaking from dispenser joint #449833
    admin
    Keymaster

    Re: Hotpoint WMUD 10637 P (UK) Leaking from dispenser joint

    You could also try using silicone between the units and then re assemble.

    Bryan

    in reply to: Wiring machines into a fused spur. #449769
    admin
    Keymaster

    Re: Wiring machines into a fused spur.

    HI

    As long as its in a double pole fused pure that is accessible and also that the appliance can be removed and worked on then there should be no problems.

    Bryan

    in reply to: Samsung rs21dcns Help #449786
    admin
    Keymaster

    Re: Samsung rs21dcns Help

    Hi

    You will need to replace defrost heater, defrost sensor, thermal fuse and evaporator cover.

    Bryan

    admin
    Keymaster

    Re: FZA50 Hotpoint future freezer, bottom drawer built up of

    Hi

    That’ll be either the defrost sensor or the fan motor ass not spinning.

    Bryan

    in reply to: Unusual Tumble Dryer Fire #449601
    admin
    Keymaster

    Re: Unusual Temble Dryer Fire

    A small amount of grease left on them…there’s enough grease on the door glass to fry your chips in.

    Common sense didn’t come into play either.

    bryan

    in reply to: LG Con T/Drier RC8001B After 1 Minute Stops? #449566
    admin
    Keymaster

    Re: LG Con T/Drier RC8001B After 1 Minute Stops?

    look at the re set on the heater stat and ive had the motor cap not kicking in

Viewing 15 posts - 121 through 135 (of 12,518 total)