[Alanj]

Re: aeg e30

Hi Johno,

have you got the p/n of the machine? Need that to give you more info.

Alanj

[Alanj]

Re: how to reprogram hotpoint wma 10 control board

Hi Andysam,

if you send me your e-mail I’ll send you a copy config sheet.

on your WMA9 try checking the wiring close to the plug on the motor the wires sometimes break at the plug but the sleeve stays intact.

Alan

[Alanj]

Re: Zanussi ZDF866W Oven

Hi Jim,

don’t have any history about oven door but there has been an inner door change.mailbox ➡

Alan

[Alanj]

Re: Smeg D/W DW1614

Hi Jim,
sounds like water in the base to me but check your mail.

Alan

[Alanj]

Re: AEG OKO LAVAMAT 72640 (914002408 01)

Hi Seamy,

although the door locks there is no life about the machine at all.

Alan

[Alanj]

Re: SMEG fault code F8

Hi Brett,

I once had one of these with a plastic medicine spoon jamming it.Worth a look :rolls: ❓

Alan

[Alanj]

Re: Servis M6516W

Hi Tim,

I think it is a design fault that Servis won’t admit to. It’s like some of the earlier Hotpoint machines that needed the sticky tar patches stuck to the inside of the cabinet.

Alan

[Alanj]

Re: Zanussi FS1455 5 beeps then 2

Dave,

it could be the tacho, motor wiring, motor or module.

Alan

[Alanj]

Re: Servis M6516W

Hi Cab

yes the mountings and susp legs look ok.

Alan

[Alanj]

Re: Zanussi FS1455 5 beeps then 2

Hi Dave,

have you got an e-mail address?
PM me with your e-mail address and I’ll send over fault diagnosis and alarm code docs.

Alan

[Alanj]

Re: AEG LAVW1050 91400242400

Hi Guys,

Thanks for all your input with the problem I’ve had with this machine.
I finally pinpointed the fault, it was the heater ntc that was faulty.Machine going great again.

Thanks again

Alan

[Alanj]

Re: GB DAR

Hey Guys,

I’ve had a couple of letters recently too ❗ Thanks but no thanks 👿

Alan

[Alanj]

Re: AEG LAVW1050 91400242400

Hi Baron,

it’s a AKO 547.703 Lux Code 132148310 Firmware ver.W1D00109

Alan

[Alanj]

Re: AEG LAVW1050 91400242400

Baron

Can you repair pcb by changing faulty triac. Is it the one clipped to the heatsink.

Alan

[Alanj]

Re: AEG LAVW1050 91400242400

anyone know where I can get a motor cheap?,it’s for my own machine.
A new one is £99.00 + vat.

Alan

[Author]

Posts