Forum Replies Created
-
Posts
-
Re: Ignis AKL898/wh static oven tripping
Are you sure it’s blowing a mcb (l/n) short and not rcd (earth fault)?? If it’s on a ring I assume it’s fused at 13a at the plug/spur and the mcb is probably 32a? So should blow 13a first anyway. I did have something (can’t remember what) that had a poor neutral ( loose connection in spur) and that was blowing rcd when switced off. Sorry if I’m rambling on- just seems wierd!!
Re: Bosch Wvd24520gb/03
I’ve got a feeling that you need to have selected the program that was selected when child lock was set to remove it. If you don’t know try each prog inturn. Alan
Re: Anti vibration mats
Yes i used one for a machine sliding sround on a tiled floor and it worked well. According to the customer there’s been no problem since. Its a bit of a bugger getting the machine on the mat if it’s in a unit tho!!! Al.
Re: ideas for red spot aeg/zanussi dryer stat on element
Must admit I’ve never done it for all the reasons you give , but saw it in ‘tipps & tricks’ and nobody commented on it so thought maybe i was just being too fussy!! Nice to know there are others like me out there. Al
Re: Neff K9524X7GB/04 Fridge Freezer
Haven’t done one for a while but basically the kit is a plug to bridge the ntc and a leaflet with a wiring diag. As far as i can remember if it’s a 3 wire plug you link pins 1&2 if it’s a 4 wire plug link pins 1&3. Al
Re: HPT W/D BHWD129 Had Module Fixed But…See Image
Check for broken wires on the dryer ntc on the heater box.
Re: Neff K9524X7GB/04 Fridge Freezer
Haven’t checked but is one where you have a mod kit that basically shorts out the evap ntc?? The symptoms sound right for this
Re: ideas for red spot aeg/zanussi dryer stat on element
Have you tried tapping the stat on a hard surface to reset it?? Sure i read this in “tips tricks & shortcuts “. Al
Re: Bosch washer
Heater relay cuts in after about 5 mins. If you switch it back on after tripping prog carries on from same place so relay cuts in straight away. I might be wrong but still sounds like heater to me!! Al
Re: Bosch washer
Probably heater. If you megger machine empty the heater is isolated. Take the front off and megger the heater. Hope this helps. Al.
Re: NEFF S5443X1GB/07 dishwasher constantly draining
Have you checked the t o c on top of the heater box?(i assume you checked the heater itself) i had one of these go after a blocked matrix – i assume because it was running short of water & you’re original fault could have caused simular symptoms.Alan.
