Forum Replies Created
-
Posts
-
Re: Bosch WVD24520GB F18 on drying cycle
If my memory serves right I had the same problem and replaced valve and was fine after
Re: John Lewis JLDV08 Dryer – repair or replace?
I would steer clear of the indesit. May pay to get an engineer to look at yours 1st. May be something simple like a motor capacitor, does it hum instead of turning ?
Re: Where is the thermal fuse on a Beko DVC665?
You sure the timer isn’t on auto. Would need resetting if cooker has been off
Re: Damaged floor
Yep I’m sure if it was down to you she would’ve been on the phone to you straight away. Admit nothing
Re: BAUKNECHT TRK5970 CONDENSER DRYER HEATER ELEMENT WIRING
I’m afraid forum rules forbid giving out wiring diagrams etc
Re: Hotpoint wm 64 big bangs !
Have to agree with jackal. It is a must to have been insulation tested before it went out. As for the fault itself it does sound pretty terminal
Re: Hygena APP2412 cooker hood
Doing one tomorrow, will take a pic if I remember
Sent from my iPad using TapatalkRe: cooker hood question
Their not earthed like said because they are double insulated. Have had loads of 3a fuses blow when the bulb goes, the chimney ones are worst where they put the plug behind the stack and almost impossible to get at
Sent from my iPad using TapatalkRe: New world fan oven problem
You’ve got the wrong stat by the sound of it. If you post model and serial no someone should be able to give you the correct part no
Re: Pinpointing this pesky gas leak
You are asking for advice on something you shouldn’t be going anywhere near if you’re not fully trained and have the necessary qualifications even if it is you’re own appliance.
For peace of mind if nothing else as Martin said get someone in thats gas competent
